Results 1 to 5 of 5

Thread: fuel pump replaced and no go

  1. 17th December 2013, 07:13 PM #1
    somosrenos Guest

    fuel pump replaced and no go

    hi .ive replaced my fuel pump with new one followed instructions ..key on key off ..but no go from pump checked resistance on pump and sender both ok hot wired pump 12v t0 pump connections ok maybe book procedure not correct for my model 1999 td5.. can someone give me some advice thank you mal
    Reply With Quote Reply With Quote
  2. 17th December 2013, 08:24 PM #2
    dullbird's Avatar
    dullbird
    dullbird is offline Admin Gold Subscriber
    Join Date
    Jan 1970
    Location
    Down the road from Sydney
    Posts
    14,702
    Total Downloaded
    0
    Hi Mate are you at home trying to sort this out?
    Our Land Rover does not leak oil! it just marks its territory.......



    Reply With Quote Reply With Quote
  3. 17th December 2013, 08:48 PM #3
    goanna_shire's Avatar
    goanna_shire
    goanna_shire is offline Master Subscriber
    Join Date
    Feb 2009
    Location
    Townsville QLD
    Posts
    258
    Total Downloaded
    0
    Your pump has a float inside it. Take ithe pump out of the tank and turn it upside down and see if it runs. Then fit it to the vehicle into the tank with enough fuel in it and cycle it on and off again letting it turn itself off (15 seconds or so). It takes quite a number of cycles doing this befor the engine has the fuel to run.

    If the pump is not running outside the tank (upside down) maybe the float is jammed down and might need a little persuading to come loose. The stupid float is supposed to switch off the pump when you run too low on fuel to save the pump but usually just causes dramas by leaving you stuck in the middle of nowhere .

    Brian.
    Reply With Quote Reply With Quote
  4. 20th December 2013, 08:55 PM #4
    Roverlord off road spares
    Roverlord off road spares is offline AT REST
    Major part of the heart and soul of AULRO.com
     Vendor

    Subscriber
    Join Date
    Jul 2012
    Location
    Tecoma Vic
    Posts
    9,642
    Total Downloaded
    0
    Quote Originally Posted by dullbird View Post
    Hi Mate are you at home trying to sort this out?
    mmmm. then it should really go to technical

    Reply With Quote Reply With Quote
  5. 20th December 2013, 09:41 PM #5
    dullbird's Avatar
    dullbird
    dullbird is offline Admin Gold Subscriber
    Join Date
    Jan 1970
    Location
    Down the road from Sydney
    Posts
    14,702
    Total Downloaded
    0
    Thats what I was trying to establish before moving.

    I think I will move it as it doesnt appear to be Urgent enough that he has come back to look and reply
    Our Land Rover does not leak oil! it just marks its territory.......



    Reply With Quote Reply With Quote
« Bent axle housing vibration | 300tdi getting hot? »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!