Thread: Advice on R380 output shaft collar/seal

Originally Posted by vbrab

Doing a change over of an R380 box and transfer case into a D1, and looking to change over fluid seals for the box and the transfer case.
Haven't separated them as yet to remove and get seals ID.
Just wondering if anybody can advise the seal part numbers (usually printed on the seal) so I can check with local bearing/seals place for possible replacements.
(nearest LR option is 1650k's away, so have to try local first as might be quicker.)

Have you thought of supporting any of the vendors on this forum.
By the time you have pulled your box part and driven to a bearing place trying to source the parts, all the correct parts could have been posted to you express for about $11 Pilbara about 2 days from eastern states, just a thought?

Originally Posted by discorevy

Gbox output ftc500010
Transfer input Icv100000
You'll want to do the O ring on the transfer case frc8292 or right size in viton

There's a a lot more seals than those , if your going to change all fluid seals

Thanks for that info, can only try the local option first, before having to go down the distance order option.

Originally Posted by discorevy

Gbox output ftc500010
Transfer input Icv100000
You'll want to do the O ring on the transfer case frc8292 or right size in viton

Originally Posted by vbrab

Thanks for that info, can only try the local option first, before having to go down the distance order option.

I buy off Rover lord off road spare, could not get a better supplyer, next day into Tassie, nearly that quick sometimes I think he is a mind reader. Local aussie supplier
cheers
blaze

Was asking after sizes or specifications for gearbox output seal and transfer input seal because being remote there was a possibility local seal guy could match.
Managed to get sizes for transfer case output seal as being 62mm (outer size), 42mm (inner size) and 8mm thick.
However, for the gearbox output seal, as mine was a bit damaged (from extraction), I have the outer size as 54mm and 8mm thick, but inner size may be 42mm OR 43mm or 44mm, but because of damage not able to get the correct size.
The diameter of the output shaft would probably give the correct inner size. \
Can anybody confirm if it is 42MM (same at for tranfer seal)?

Yep , same size inner , you will need to replace the seal collar as the new seal will get damaged trying to fit over the collar, unless you have a new one there is a vendor on here that should be able to supply apparently. You'll need access to a hydraulic gear puller though