Reply With Quoteunplug the switch then get a jumper wire and put this in the plug going to the lights if they work then it could be the switch (may be a worn detent or shaft)
ChatterBox
First post so I hope someone can answer ....
What's the best way to get at the reversing light switch on a '96 manual Tdi disco - go down through the top ( removing the gearstick boot etc ) or go from underneath.
I had a look from underneath - I think I can see it up there but can't reach it.
My reversing lights don't work at all - I suspect the switch. Could it be anything else ?
Wizard
Supporterunplug the switch then get a jumper wire and put this in the plug going to the lights if they work then it could be the switch (may be a worn detent or shaft)
disco seriesII mods so far:-bullbar,hyd winch,
detriot locker,lsd front,C.D.L kit,chipped and bigger intercooler,2" lift,rock sliders, lsd in transfer case, modified auto trans.
In the event of nuclear war,Disregard this message
AT REST
G'Day mate
Go down through the top
an you can use a meter to test the switch, bugger of a thing to get at from underneath
hope this helps
Tony
ChatterBox
you might be better getting at it from the other end. check the lights first and work backwards. you may find it's a broken wire or a bad earth.
LAND ROVER;HELPING PUT OIL BACK IN THE GROUND FOR 70 YEARSCARS DON'T GET ANY "GREENER" THAT.
ChatterBox
Thanks guys I'll have a play on the W/E
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks