Thread: HELP suspension faults 2003 RR td6

After some help from the brains on early TD6,s

Today I replaced the piston repair kit as well as the air dryer filtration.
Put it all back together and it does not want to work.

I had it in access mode when I took it out and when I put it back in
the arse end went up to high and the front stayed where it was.

Took it back out and checked I had connected everything up the way its supposed to be(twice)
and its still giving me grief.

IID tool codes........

0X8 High Pressure Exhaust Valve Fault
018 High Pressure Valve Supply Fault
0X24 Compressor Temp Sensor Fault
0X7 Exhaust Valve Fault
076 Reservoir Pressure Drops When Filling

Have cleared the faults and now they wont show up,but car still arse up, nose down..

Any ideas what could be the problem greatfully appreciated.
TIA

DG

Went for a quick drive around the block and it has reset to normal height as I read somewhere that that will reset suspension.
It did

The front seems to be a bit higher than normal (510mm), thats from the centre of wheel to body at the front only.
It looks as if its slightly in extended mode,but not quite fully extended,hope that will resettle in the drive tomorrow.
Control light in car is in the middle as it should be.
Rear seems to be OK height wise.
Hopefully it will settle when I take it for a spin tomorrow.

DG