Page 1 of 2 12 LastLast
Results 1 to 10 of 16

Thread: Running on

  1. #1
    Join Date
    Jan 1970
    Location
    Barwite. Victoria
    Posts
    1,695
    Total Downloaded
    0

    Running on

    Why would my POS 3.5 keep running on after turning it off, I have adjusted the timimg (spot on) also have electronic dizzy...

  2. #2
    lokka Guest
    Maby hot spots in the cyl 's causing the fuel to ignite after the spark is shut off tip warm water down the throat of the carby or through the throtle body while reving the engin at about 1500 rpm and watch the cr@p fly out the exhaust this will clean all the carbon deposits in the combustion chambers and may fix your prob

    cheers

    chris

  3. #3
    crossy Guest
    X2. But why warm water? never heard that before.....

  4. #4
    lokka Guest
    Warm water works better than cold as it dosent cause a cold rush in the chambers i do this regular to engins as it decarbons the chambers and reduces the risk of hot glowing carbon deposits ignighting the fuel after the spark is shut off

    Cheers

    Chris

  5. #5
    Join Date
    Jan 1970
    Location
    SYDNEY -in the shire.....
    Posts
    8,196
    Total Downloaded
    0
    and not too much too quickly or you may hydraulic lock the engine......

  6. #6
    Join Date
    Jul 2006
    Location
    Brisbane, Inner East.
    Posts
    11,178
    Total Downloaded
    0
    I bought a new MG-B in 1965 and it used to run on from new. It needed higher octane petrol than the super grade available here at that time. I also had an EH Holden at the same time and it needed higher octane petrol also, bu it didn't run on, just pinged. Adding benzol/methyl benzine at 5 of petrol to 1 of benz. fixed the Holden but not the MG. Probably combustion chamber design.
    URSUSMAJOR

  7. #7
    Join Date
    Jan 1970
    Location
    Yass NSW
    Posts
    7,239
    Total Downloaded
    0
    Last time I had a car do this was because it was stuffed. Cause it was so bad the last time it ran after shutting it of was just pulled up some chairs and waited the 30mins it took to die. It was billowing smoke and steem from everywhere

  8. #8
    Join Date
    Jan 1970
    Location
    Alstonville...is near Byron Bay
    Posts
    3,034
    Total Downloaded
    0
    Land Rovers just keep going and going and going and going..........

    and

    this was a big issue when anti pollution bolt on stuff arrived in the late '70s...

    just a thought...

    GQ

  9. #9
    Join Date
    Jan 1970
    Location
    Barwite. Victoria
    Posts
    1,695
    Total Downloaded
    0
    The new motor is only approx 5000 kl old

  10. #10
    Join Date
    Jan 1970
    Location
    Forty minutes closer to the hills in a house the bank is kind enough to let me live in
    Posts
    1,532
    Total Downloaded
    0
    My old Fiat 124 used to run on if you turned it off at idle. The simplest way to stop when you wanted to was to park, rev it with a short sharp stab of the pedal and kill it just before lifting your foot. It would just spin down normally. Never really bothered trying to fix the problem once I worked that out.

Page 1 of 2 12 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!