the buzzers can be made quite by filling the speaker holes up till you get the right volume
The other day I looked down and noticed the rear Maxi Drive locker light was on and locker was engaged ( Don't know how I must have bumped the switch or something )
Luckily I was on dirt road, but if it had been on blacktop it could have done some damage.
So what i'd like to do is attach an audible warning beeper to the "locked" indicator light. However I'd like to have something that just gives a not too loud, short reminder beep every minute or so. All the buzzers/beeprs I have seen at Jaycar or Dick smith are screeching loud and go continuously.
Does anyone know of an intermittent 12V beeper or buzzer that will do what I want, straight out of the box ?
I could make something up with a 555 timer chip but that involves soldering, circuit boards etc and I am looking for an easy way out.
tks in advance
Last edited by waynep; 22nd May 2007 at 10:10 AM.
the buzzers can be made quite by filling the speaker holes up till you get the right volume
disco seriesII mods so far:-bullbar,hyd winch,
detriot locker,lsd front,C.D.L kit,chipped and bigger intercooler,2" lift,rock sliders, lsd in transfer case, modified auto trans.
In the event of nuclear war,Disregard this message
silent but deadly, with my arb lockers i hear the compressor start
i cannot help you on the buzzer but i am always worried when megs is driving the defender that the lockers may be engaged. i have an extra switch to isolate the compressor, actually i don't think megs knows where the second switch is!!
Want an intermittent chirping noise?
The tyres will tell you first tight corner...
Regards
Max P
I was thinking of a reversing beeper too but built from a kit (which I thought was available but I can't find it!) and alter the timing components.
Dick smith also used to have a 'cricket' kit which made an intermittent chirping noise.
...or put a flashing LED in your dash? http://www.dse.com.au/cgi-bin/dse.st...uct/View/K4200
without pulling out a wiring diagram from my RAVE, I wonder if it wouldn't be at all difficult to tap into the wiring of the centre difflock to illuminate the dash light
lock the centre diff out, pull the dash apart and use a multi-meter/test light to find the wire sending power to the light globe.... bit of stuffing round but works.
wiring diagram sounds like a better way tho
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks