Now the serpentine belt has let go.

**Bushwanderer** · 21st December 2007, 11:19 AM

Originally Posted by Tusker

At precisely 100,007 kms. Split in two, thinner bit mangled, the major bit intact, but jumped.

All this on the M2 in Saturday's rain. Engine started missing, noticed the temp gauge is hopping about in the red. Pull over, obvious the power steering isn't working. And steam appears.

Just after a service too.

Spent yesterday putting a spare belt on. A couple of hours figuring how it ran, 15 minutes to run it, another couple of hours to figure out a way of letting the tensioner off.

Couldn't have done it without some phone calls, thanks Slunnie.

Anyway, it fires up ok, but theres a death rattle in the top end. Sounds a bit like a big end knocking.

I can do without this!

Regards
Max P

Hi Max, Why do I have this horrible feeling that it was GC?

**keith** · 24th December 2007, 09:33 AM

now I find out that the new replacement belt (non genuine) which is marked as the same length is longer!!! fits but slips, Beware

Cheers Keith

**keith** · 28th December 2007, 09:55 AM

OK now the belt has stopped squeeling and I can just hear the other squeel from where the front stud has let go on the exhaust manifold. I have the new studs and manilold gasket, are there any tricks or is it reasonably simple to get everthing off and replace?

Cheers Keith

**Bassifier** · 29th December 2007, 07:19 AM

Beware to not overtighten any bolts in this game cause if one gets stripped slightly it will loosen eventually and throw the belt.
Obvious I know, but I've had a major dealer cause me no end of broken belts due to a overzealous mechanic

Thread: Now the serpentine belt has let go.

Thread Tools

Bookmarks

Bookmarks

Posting Permissions