Thread: wheel bearings seal

RTC 3511 is the best one to use. Mount it 4mm below the hub face.

Check this thread-
http://www.aulro.com/afvb/showthread...bearing&page=3

Part number RTC3511

Cheers
Simon

i should of put in its the rear wheel bearing,are these the same.i have read the thread about the turning hubs and have put it on my gunna do list

same hub seal front and rear.
The RTC3511 seal is a spring energised, double lipped seal, suitable for oil lubed hubs and works fine if you only use grease, too, as it keeps water out which can't be said for any other Landy seals.

thanks people.i will look in darwin for this seal.also noticed the the plate the seal rons on has gone all pitted so will have to find one of them also,probably what caused the problem in the first place

use a Speedi-Sleeve to fix the seal surface problem. Should be available from any bearing service.

Probably easiest to get the seal freighted to you from Sydney/Brissy/Perth/Adelaide or Big Jon in the Alice (Sutton Motors)

thanks for that. sounds cheaper too.can you get them for steering box shaft as well

Originally Posted by lewy

does anyone know the part number for the wheel bearing grease seal on a 93 series 1 disco.preferably the double lipped types

With some of the early seals, landrover in their wisdom were supplying seals where the lip was **** about face, you had to put the seal in backwards for it to work properly. then along came a modification as usual.

cheers Sumo