Maxidrive Non Lock

Quote:

---

Originally Posted by Waxenwane

Very entertaining..........But what's all this talk of boring the stub axles on Maxidrive installs? My axle withdraws and the stub is not bored, also another that I have seen is the same. Did Mal change something?

---

How old is your maxi? V1 with 28 spline or V2 with 24, early stuff fits through the stub, somewhere within the late stuff, the stub must be removed to insert the axle and the stub fits over the outer spline only

Not that I know much, as shown above:D

Quote:

---

Originally Posted by walker

Stub axle? Not sure what you mean. I think a lot of people use different terminology when it comes to diffs and axles which makes it a bit confusing.

This is what I remember from having mince out a little while ago.

On the rear you have 2 half shafts only. These run from the diff to the cap on the hub. No other stub axles that I can remember, unless you have non standard rangie gear.
It was the brass bush that stops you being able to completely pull out the axles without diss-assembling the hub.

I hope I have that correct. I am sure someone will let me know if I don't! ;)

---

Spindles, if that suits your terminology better;)

Quote:

---

Originally Posted by sclarke

I'll never get banned again....

I'm over all the web wheelers and i just sit back now and watch... unless i get personally attecked then i dont give a toss... makes fun reading thou

---

Your Mums a girl:p









Whats an atteck??:confused:

Quote:

---

Originally Posted by rangieman

Popcorn smiley please matt :wallbash::Rolling:;)

---

https://www.aulro.com/afvb/https://www.aulro.com/afvb/https://www.aulro.com/afvb/

Quote:

---

Originally Posted by rovercare

Whats an atteck??:confused:

---

It is a NZ "attack"

Quote:

---

Originally Posted by B92 8NW

It is a NZ "attack"

---

:Rolling:
:BigThumb::Rolling:

Quote:

---

Originally Posted by B92 8NW

It is a NZ "attack"

---

Quote:

---

Originally Posted by walker

:Rolling:
:BigThumb::Rolling:

---

X2 :p :p :p :p

Quote:

---

Originally Posted by B92 8NW

It is a NZ "attack"

---

I rusunt that.

Quote:

---

Originally Posted by rovercare

How old is your maxi? V1 with 28 spline or V2 with 24, early stuff fits through the stub, somewhere within the late stuff, the stub must be removed to insert the axle and the stub fits over the outer spline only

---

I have seen a stock (defender front) stub/spindle that could just fit a 30spl (1.31") longfield shaft through without boring. So there must be a pretty large variation in Rover tolerances.

To me that makes the comments about stub/spindle strength with 24spl conversions moot.

Quote:

---

Originally Posted by rovercare

How old is your maxi? V1 with 28 spline or V2 with 24, early stuff fits through the stub, somewhere within the late stuff, the stub must be removed to insert the axle and the stub fits over the outer spline only

Not that I know much, as shown above:D

---

It's V2 24 spline, could have sworn the axle fitted through the stub, but I must be confusing it with something else.....ah well you get that.:o
Thanks for the response