Reply With QuoteOne trick is to machine off a few thou
and apply a layer of weld to build it up
That will shrink the collar
and machine to size
works with sloppy yolks on the diff too
been doing it for years no problems .....Mark
Super Moderator
A little advice and/or reassurance, am replacing the bearing on the front inner halfshaft and find that the new collar is not a tolerance fit. It slips easily on and can be removed as easily.
The engineering answer is to get another collar with the correct tolerance.
Given that the bearing actually can slide in and out of the inner race and one of the purposes for the collar is for the oil seal. Would others feel that using a bearing mount solution would be acceptable for a vehicle that will not do large distances? Or should we try to get collars from alternate suppliers?
Diana
You won't find me on: faceplant; Scipe; Infragam; LumpedIn; ShapCnat or Twitting. I'm just not that interesting.
Master
SubscriberOne trick is to machine off a few thou
and apply a layer of weld to build it up
That will shrink the collar
and machine to size
works with sloppy yolks on the diff too
been doing it for years no problems .....Mark
Super Moderator
I may have to take a drive up to your place and you can show me
My other option is to get the micrometer out and check if our S1 rear axle collars are any good for a SIIB ENV front?
Diana
You won't find me on: faceplant; Scipe; Infragam; LumpedIn; ShapCnat or Twitting. I'm just not that interesting.
Master
SubscriberI think i might have 2 new S 1 collars somewhere
and probly a few S/H ones in the clutter.......
selective fit, Pain in the bum..........Mark
Master
SubscriberI would presume that ENV collars would be larger than series ones
I would have to see if i had some round bar to make a tapered mandrell to machine one. Not a 10 minitue job but do able............
Super Moderator
Actually SIII swivels are the SIIA forward control part and the bearings, seal and supposedly the collar are all the same. The difference is that the shaft doesn't taper and the OD of the ENV spline are about 0.005 - 0.010" clearance so your S1 or SII may fit.
You won't find me on: faceplant; Scipe; Infragam; LumpedIn; ShapCnat or Twitting. I'm just not that interesting.
Master
SubscriberDiana
I found the two series 1 collars
1 01.369.5
2 01.370.5
i am sure they mexican brand
cant find the ones that i pulled off "they may turn up"
I have a few saries 2 3 axles that i can press off i you are stuck
you are welcome to the 2 new ones .........Mark
Super Moderator
MarkOriginally Posted by groucho
I'm not sure we are on the same page.
I measured the OD of the shaft with my metric / 1/128 imp micrometer and I get 34.85 mm or 1.250" what am I doing wrong?
Addit: Yes I am stoopid!That or I need new specticals!
Are you home today?
Last edited by Lotz-A-Landies; 31st December 2009 at 09:12 AM. Reason: Addit:
You won't find me on: faceplant; Scipe; Infragam; LumpedIn; ShapCnat or Twitting. I'm just not that interesting.
Super Moderator
Mark
Thanks
Diana
You won't find me on: faceplant; Scipe; Infragam; LumpedIn; ShapCnat or Twitting. I'm just not that interesting.
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks