New plan for tensioning my output shaft:
This way it can all be done in-situ (once the LT230 is removed) to see if it works or if there is another source of my rumble. I can send the shaft off for boring (or EDM if it's too hard to bore) and get the internal nut made once I confirm the thread on the output shaft.
Cap screw and o-ring are bits I already have here for other jobs.
Mainly I avoid having to drill/tap the MSA output shaft. Which means I don't need to pull the gearbox from the vehicle.
Existing setup is below
![]()



				
				
				
					
  Reply With Quote

 may i add another project to your future list while your at it....compound turbos!!!! 
 so pretty much the isuzu just feels nicer and more fun 
				
Bookmarks