lighter clutch

you could always fit the assiting device (the one every one takes out) from a disco and the disco slave.

Assisting device?

Quote:

---

Originally Posted by steveG

Have you tried the isuzu slave? There's quite a bit of difference in piston area (roughly 506mm2 vs 706mm2). Should make a noticeable difference, assuming you get enough travel...

Steve

---

Don't have a part number by any chance??

What if I was to change to a larger bore master cylinder as well? Would this help?
Sorry not up to speed on hydraulics:(

No part number sorry. Assumed you had one when you said they were 30mm.
No, you don't want to go larger on the master, that will make it worse.
Hydraulics is sort of like gears. Small input gear and large output gear gives large output force, but not much output distance.

Steve

Was just reading some other posts and it seams the truck one is 30mm, county 25mm.
Sheldon is going to try chase up the part number for me, his only concern is if it will have enough throw.

Actually Steve, turns out after some googling, my slave is an Exedy SC810, that suits a disco! From what I have looked up, that has a 7/8" bore, no wonder I'm struggling:(

Quote:

---

Originally Posted by Vern

Actually Steve, turns out after some googling, my slave is an Exedy SC810, that suits a disco! From what I have looked up, that has a 7/8" bore, no wonder I'm struggling:(

---

Yes, that would make a difference.

Here's an Isuzu one on ebay: Clutch Slave Cylinder Assy FOR Isuzu NPR 59 1987 1994 | eBay

Steve

was thinking might try this?
15651.009 CLUTCH SLAVE CYLINDER ASSY ASSEMBLY NPR59 1984- 4BD1/T 3.9L 1984-87 SLAVE CYL 1984-87 8970328490 8970328490 31470.927 2J1807 210D0012 8941012380 - Truck Parts and All Filters Hino Isuzu Fuso Mitsubishi Mazda Nissan Ud Toyota Dyna Delta

ordered:D