Pulldown and inspect of my ex army 4bd1-t

Your zf will not last, don't waste your time sorry. Either go the lt95, or look at some of the kits sheldon is doing.

Quote:

---

Originally Posted by Geeman

The engine was of the 6x6 Landy engine so I assume it has a Landry bell housing! Now will a zf4hp24 bolt pattern be the same as the Isuzu/Landry housing or do I still have to make an adapter plate?

---

Just to clarify, what you've shown in your photos is what I know as the engine adaptor or flywheel housing. I assume that's the Landy one.
Bellhousing is the bit that bolts onto the flywheel housing, and then has the gearbox bolted to the rear. Clutch fork and release bearing lives inside, and the clutch itself is half in the flywheel housing and half in the bellhousing.

Unless you've got one stashed elsewhere, I didn't see a Landy-Isuzu bellhousing anywhere in your photos.

Steve

Yea , sorry my bad, I only have the Landy/Isuzu flywheel housing!

Quick update, i know its been a while!

Anyway i have recieved my full gasket kit from isuzu and im looking at ordering a set of main and big end bearings.

Once i have recievd them the motor will all start to go back together!

Once motor is test run i will be selling it, if anyone is interested let me know!

Cheers Goran