Yeah, mate, I must admit I do because it is in such good nick and the motor has already been rebuilt. Motor runs like a dream, I am aware of the horror stories with regards to K series engines.
I bought some 'Bars Leaks" this morning down at Super Crap and put that in. The leak had sealed itself up before I put it in so it is only a pinhole one. I put the Bars Leaks in and let the car idle for half an hour and then took it for a couple of drives around the block and all seems OK. I would say what happened is the previous owner had the leak and put a radiator stop leak in and the chemical flush with a pressure clean has disturbed it. With a bit of luck all should be OK on that front.
Wifey is now down at Aldi's at Glendale, she wanted to go yesterday but I could'nt do anything about the car because I was working, so I would'nt let her take it. She was suffering shopper withdrawal symptoms real bad, and when I said it should be right to take down to Glendale, you should have seen it ZZZZOOOOMMMMM out the door, with me yelling after her, keep an eye on the coolant level, thankfully she does have brains in that department,unlike a lot of women who would'nt have a clue on things mechanical.
I will still take it back to the radiator guy on Monday for a pressure test, I will also ask on the cost of fitting a low level coolant alarm, ALL4X4 want $200 to fit one on top of $200 to buy the alarm, if I am having radiator problems I am playing with fire driving without one as the temperature guage is quite useless I am led to believe.








				
				
				
					
  Reply With Quote

 I will still take it back to the radiator guy on Monday for a pressure test, I will also ask on the cost of fitting a low level coolant alarm, ALL4X4 want $200 to fit one on top of $200 to buy the alarm, if I am having radiator problems I am playing with fire driving without one as the temperature guage is quite useless I am led to believe.
				
) because the tranny fluid had softened the rubber on the old one and it wasn't holding pressure. I saw them on the counter for $200 and I asked the bloke "how much to install" and he said $200, which I think is a bit rich for a job that should take no more than an hour for an experienced guy!!
Bookmarks