You could always do one your self?Quote:
Originally Posted by AnD3rew
I have stored the full copy minus the installation part in my glove box, and I also store a digital version of documents like this on my phone. Always have a back up! ;)
Printable View
You could always do one your self?Quote:
Originally Posted by AnD3rew
I have stored the full copy minus the installation part in my glove box, and I also store a digital version of documents like this on my phone. Always have a back up! ;)
Graeme just wanted to report my ecstatic view again on this product! Installed new amk compressor, and got the software updates and reset suspension ecu and it still works a treat. I was expecting to have to reset it, but very happy to not have to worry. Thanks!
I'll look at providing a quick reference card similar to the brief instruction label that's inside the black box.Quote:
Originally Posted by AnD3rew
Hi Graeme and all... I received my kit in the post last week and attempted to fit it whilst away over this long weekend. After fitting I could not clear the suspension error message even after several resets, checked the loom and disconnecting and reconnecting the battery etc.
In the end I just had the loom fitted with the serial port connected to make a pass through. I still had the error with this so conclusion is it could be the wiring loom at fault or is there something else I should be trying?
Rich.
Hi Rich,
Your conclusion is most likely correct. I will post a replacement loom today.
Thanks Graeme. All installed and working.
Can anyone suggest a place to mount the rotary switch in a MY13 RRS? The steering column spot is already occupied so looking for other suggestions. I've not seen the insides of any late model RRSs.
TIA.
I have discovered that the source of suspension faults caused by lost loom connections is likely to be at the loom join of the 2 grey connectors. This is due to the pins in the Llams grey male connector being short combined with the Llams shell being somewhat flexible which allows the 2 connectors to partially come apart.
I recommend that a cable-tie be fitted around the middle of the 2 grey connectors, threaded through both bundles of wires to prevent any future problems. Future kits will include a cable-tie for this purpose.
A picture showing how the cable-tie is fitted. Please excuse that I have used 2 Llams looms for ease of taking the picture.
http://www.aulro.com/app/data/1093/Cable-tie.jpg
Mods, I hope this is ok to do.
I would just like to thank Graeme for his assistance in relation to my Llams unit. I had a very minor issue with mine and sent a PM seeking help. I received a very prompt reply that sorted the problem and had me on my way again.
Matt.
p.s. I have no vested interest in the product or as a result of my statement. I simply wanted to acknowledge good support in the hope that it continues for the benefit of everyone.