Thread: Defender / County 'wing top' stainless vent.

I like the SS ones I purchased

Having a wing protector with the vent built in would be a pain if you wished to get access to the top of the guard.

The factory ones are recessed into the wing on my 2002 defender so you'd have no support under that section if the wing protector was laser cut with vent holes?

Just my thoughts

Originally Posted by VladTepes

The problem I see if they are integral to a wing top protector is that once you've secured that in place, you'll never be able to get anything / your hand or whatever down there which may be required to fix something ?

Would look good though.

Originally Posted by rijidij

Good point.

Maybe they could be fitted with rivnuts and countersunk bolts, and instead of sealing the edges with silicone which is effectively glueing them down, they could be sealed around the edge with good quality foam tape which only sticks to the underside of the checkerplate, but not to the paint. Then it would just be a matter of undoing the bolts to lift them off.

Cheers, Murray

That'd work.

A couple of times in the last ten years I've had to remove the OE cover to get debris out of the duct and help clean the duckbill drain.