D2 ACE speed signal modifier

Andrew, it has a 3-way toggle just as you describe - normal, rough road and unlocked. The price is $60 as shown in the first post. I'll PM my a/c details when I have a couple of them ready - easier to make 2 at the same time rather than have to work out how I did the last one each time.

You must have had a hand in fixing "my" lane recently because its a racetrack now, until it rains again at least.

AWESOME!!!
As soon as you send the details I will send the coins.
Cheers
Andrew

Could the person who found the leads a bit short suggest better lengths for the switch and power/signal leads please? I can't remember how long I made them but think they could have been around 1.2 metres each. If only I hadn't sold my D2...

Quote:

---

Originally Posted by Graeme

Could the person who found the leads a bit short suggest better lengths for the switch and power/signal leads please? I can't remember how long I made them but think they could have been around 1.2 metres each. If only I hadn't sold my D2...

---

Greame
Rough measurement.LHS of glovebox across and up to LHS binnical is 1.2m so allowing to run cable around items behind the dash could be tight.1.5m may be better????
If you need a closer measurement let me know where the cable needs to run,will do a dummy wire and measure.
Andrew

Thanks Andrew. I'll make a 1.5m ACE ecu to module lead and a 0.5m module to switch lead which would allow the module to sit on the tray above the pedals and the switch mounted anywhere nearby.

I did ask about making it longer as I was/will eventually fit it under the rear of the centre consul cubby. So long enough for the full length of the consul and then across the dash to the ECU.

Attached are fitting instructions for the ACE speed signal modifier. I have made the ecu to module lead 1.5 metres and module to switch lead about 75 cm. The module doesn't have to be accessible once its jumper has been set and proven to work. I'll PM a/c details.

Quote:

---

Originally Posted by clubagreenie

I did ask about making it longer as I was/will eventually fit it under the rear of the centre consul cubby.

---

Do you need an extension for the ACE ecu to module lead and if so, how long does it need to be?

Note that the kit contains a small 4-pin loop-back plug that can be used to provide ACE with the normal speed signal if the module is temporarily removed. It has the 2 signal pins bridged.

Hi Graeme, I will take one for my D2 as well please. Pm details of payment etc.

Cheers,
Mike