Thread: County rear drawers

Originally Posted by LRO

Hi
How did you bend the draw and what are the measurement of it. and what sort of bearings are they. And well done they look very good

I had the steel supplier fold it but wish I had of done it, I have access to a pan brake to fold it but was worried that I would stuff it, but would have been better doing it my self as it was folded up abit out of square.

measurements: 900mm x 700mm. 1.5mm thick.

the bearings I have had for awhile and now can't remember the part number, just go to a local bearing place. there about 40mm with a 12mm hole.

I made this set up for my first camping trip last year, it worked really well although a little on the heavy side
As I use the vehicle for work too, the storage boxes are really handy for tools etc.The drawer runners were $62 from ebay and will hold 90kg. I've now discovered a scource for E Lite Plywood, so I'm going to remake the same again but it should be 2/3 lighter. I'll then cover with carpet to match interior.

Total cost was about $95.00

looking good lamby. you werent able to weigh them before you put them in?

geckos

My 2c worth. Get some edge moulding and put it over the inner lip. this will prevent you cutting yourself on the edge and also gives a neat finish. That's what I did on mine.

Hi
How deep is the draw Thanks