Thread: Stuck!!!! Fuel pump acces hole placement

Mulgo makes a kit i am pretty sure which allows future access, i assume it would come with directions

Fuel Pump Inspection Panel - Mulgo Pty Ltd - Australia

This might help.

Thanks that's exactly what I was after , looks right from what ii can see to

Cheers I tried mulgos sight but couldn't find instructions though

How many k's has your pump done?

Those are the same measurements that I used (2004 110)
but i'd probably go another 10mm toward the front of the car

be careful as you can catch the fuel lines with the saw,
Also there are some support braces that you need to cut thru,

I did not like the idea of cutting all the way thru the steel brace so just scalloped it , hopefully its enough to jiggle the pump past if I ever need it.

You may need to make up one of these tools to make undoing the clamping ring a bit easier in the confined space.
Knob on top is actually an old 1/2 inch drive socket.

had the same problem screaming pump replaced pump , still screamed after replacement only time its quite is when the tank full and also got trouble stating sometimes seems to me to run out of fuel , runs for5 secs and dies have to then prime for about 2-5 minutes and the it (hopefully )starts
very frustrating i must say