Thread: My 86 Rangie Hiline

Hi Dave, thanks for that console, it fits quite well, and will be a great start for everything. Will still need to modify the hi/lo shifter and add some fibreglass to the sides to get it to cover the tunnel where I need it to, but that will be easy compared with starting from scratch.

Do you have the hi/low shifter gator and a few of the other bits for it?

Cheers - Gav.

Yes Gav I have the H/L Gator and what ever else you need somewhere in one of the piles. I have the Hi/low selector from a RRC auto as well. I wonder if the lever is longer. Probably to late to swap now though.

I'm on Annual leave this week so will be around. Just call to check before hand.

Gav

Wishart

83 Bakehouse Rd, Kensington, Victoria, 3031 (Enter from 50 Lloyd St)

Phone: 03 9329 8792


Fixed my wifes Astra air con for $250 compared to $900 at the dealer.

They do a lot of air con repairs for the smash repairers.

Cheers

Floor is back down permanently, with everything underneath finished, checked and double checked, so there should be no nasty surprises lurking there.

The console from the Disco donor car will work with some small mods, this also required the hi/low shifter to be modified a bit, but everything is in the right place now.

Ordered new carpets and soundproofing as well, from a company that is just finishing the moulds for the 4 door RRC, so I'll report once I have these and have fitted them. I am going to soundproof the entire interior I think, including the roof, so that should make it as quiet as is possible. I'll post photos once that is done.

So, only got to stick the seats back in, go over everything in the engine bay, stick the bullbar back on, then it's off to Vicroads for the club rego...

Getting excited, and looks like I'll be done in time for a few shake down runs to make sure I tightened everything up properly before its big trip to Melrose.

May even have time to start the interior fit out, but we'll see how we go.

Cheers - Gav.

hi how did you wire the 3.9 to the 86 any info would be great cheers john

Hi John, had a few 'head scratching' moments, but other forum members here got me through those bits. I used the complete engine loom from the Disco donor vehicle. This takes care of the ECU - which I mounted behind the dash to the RHS of the steering column, so I will be VERY wet before that goes under and I would imagine my ignition would let me down while playing in the mud & water long before the ECU goes for a swim.

Off the top of my head, I only had to stick in a constant 12 volt supply, a switched ignition supply and the fuel pump wiring to get it to work - oh, and the feed from the ignition to tell it the engine was turning - I got caught out with that - it runs through a resistor.

Also had to fit an EFI tank and new fuel lines, but I had the floor up, so that was quite easy.

Everything else is how it was with the carby V8 in it. The wiring diagram I used was available on line - there are a few links to it around - I'll see if I can dig it up.

Cheers - Gav

hi gav much appreciated for the help this is my first rrc cheers john

No probs mate. Let me know if you need any more specific details. Everyone on the forum here is always willing to help. I've never found an issue on my lot that someone else hasn't already had and knows how to fix.

Hope you enjoy your RRC, they are a great vehicle.