YarnMaster
Ok guys, old engine and old computer removed and new 4.6L put in,they dont muck around.. ahh only one fan belt too
YarnMaster
Engine getting wired up, Wolf computer installed in watertight box under seat.
Wolf 3D Stat screen installed on dash at correct vision angle.
Rear Maxi and upgraded transfer are also going in this week
Front and Rear bar work mods,winch and rear wheel carrier are getting started next week
Can you move the computer up behind the usless right vent in the dash? Should fit on the lower cowling nicely. Then the deep water wont bother you at allOriginally Posted by blackrangie
Engine getting wired up, Wolf computer installed in watertight box under seat.
Wolf 3D Stat screen installed on dash at correct vision angle.
Rear Maxi and upgraded transfer are also going in this week
Front and Rear bar work mods,winch and rear wheel carrier are getting started next week
YarnMaster
We think alikeCan you move the computer up behind the usless right vent in the dash? Should fit on the lower cowling nicely. Then the deep water wont bother you at all
He assured me though, that water would not get in, its completely sealed!
I'll let you know how it goes the first time i drive her half way up the windscreen in water
He's been building modded and race Rangie's for a long time so i didn't argue.
A few things worry me with that setup. looms along the hot floor, Nothing is ever 100% water tight unless epoxy is involved, heat to the ecu, a bastard to get at.We think alike
He assured me though, that water would not get in, its completely sealed!
I'll let you know how it goes the first time i drive her half way up the windscreen in water
He's been building modded and race Rangie's for a long time so i didn't argue.
He obviously knows what he is doing though
Well bugger it I'm still sticking my ecu and control relays up in the dash with little waterproofing other than silicone spray. If I get that much water on board I'll have other problems
It can happen... We took a few inches of water in at Morton island just playing in a water holeI was damn lucky the ecu didn't chuck it in.
YarnMaster
Good points mate,will let you know how mine turns out, can always move up later if its not going to be reliable under their.A few things worry me with that setup. looms along the hot floor, Nothing is ever 100% water tight unless epoxy is involved, heat to the ecu, a bastard to get at.
He obviously knows what he is doing though
Well bugger it I'm still sticking my ecu and control relays up in the dash with little waterproofing other than silicone spray. If I get that much water on board I'll have other problems
It can happen... We took a few inches of water in at Morton island just playing in a water hole
My ecu.
YarnMaster
Perfect!
What ecu is that?
OldBushie
Delco
YarnMaster
SubscriberMy ecu still sits on the floor undernearth driver seat , I have pretty much sealed the entire rangie floor , metal plates cut and rivotted with lots of sikaflexdriven thru a few bog holes already and the carpet and trim has stayed dry .but as Tony has hinted you would probably want to tidy up the wiring loom laying on the floor around the transmission pan, does get quite hot there.
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Reply With Quote
Bookmarks