Rear stub axle seal

**mandala1111** · 4th July 2015, 10:23 AM

Hi Folks.
I have had a rear oil leak from around the stub axle and I just pulled everything apart to find the small inner stub axle seal had fallen off and was just sitting there inside the axle housing.Any ideas so this won't happen again would be muchly appreciated.Also am replacing wheel bearings due to the inner one had totally fallen aprt,all bearings had come out and was in a real state.Heard a grinding noise the other day,at least that solves the noise I was hearing.
Cheers Shane

**Homestar** · 4th July 2015, 11:02 AM

If you had a colapsed wheel bearing, that would put a mechanical sideways pressure on the seal and could cause it to pop out I would think. New bearings and seals should see you right for another couple hundred thousand KM.

**mandala1111** · 7th July 2015, 05:05 PM

Thanks Bacicat,my thoughts also.Hopefully all will be fine with new bearings and seals.Have to wait for a new hub first as that is a bit worse for wear from the bearing failure.

**p38arover** · 7th July 2015, 06:34 PM

While you are at it, convert to oil-lubricated bearings. Early cars were oil-lubed and never had a problem. Later cars used grease.

See http://www.aulro.com/afvb/good-oil/5...ting-rest.html

and wheel bearings D1

and http://www.aulro.com/afvb/projects-t...-tutorial.html

Thread: Rear stub axle seal

Thread Tools

Rear stub axle seal

Bookmarks

Bookmarks

Posting Permissions