Reply With QuoteYou will need to use a puller to get it off the driveshaft, I used a 3 arm puller and it was still not that easy to remove
If you are just pulling it from the hub carrier it should eventually cone free with a bit of persuasion
Hi Crew.
I am fitting a new front Axle seal and have removed the caliper and disk and the 4 bolts holding the front hub on, the Rave disk tels me there is only the 4 bolts holding the hub in but i can not get it free. I have been able to rotate it anout 5 mm by wacking the crap out of it to the point that I am concerned that the bolt whole are no longer round.
any tips on removing the front hub?
CHeers
Matt
Master
You will need to use a puller to get it off the driveshaft, I used a 3 arm puller and it was still not that easy to remove
If you are just pulling it from the hub carrier it should eventually cone free with a bit of persuasion
Thanks for the quick reply. I am hoping the leave the hub on the axle as I did on the rear hub when I did the o ring. Looking at rave the axle should just come fee with the hub shouldn't it?
Matt
Master
Yes they just pull out with the driveshaft, maybe try some penetrating oil an work it a bit?
Good luck with it
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
AULRO.com Copyright 2001 - 2025 Independently Owned and Operated by Dave Blears Computing - DavecandoIT - AULRO.com LAND ROVER and its logo are the registered trademarks of Land Rover. Land Rover is not affiliated with AULRO.com. |
|
Bookmarks