Thread: Replacing rear side panels - what's involved.

I think Baz (Redback) replaced a rear panel at some point, perhaps shoot him a PM?

Is it just the corner section housing the taillight or the side guard (wheel arch) section as well?

The book shows them as individual items, the corner ASR2220/2221 RH & LH respectively and the bodysides ASR1084/1085 again RH & LH respectively. But it also noted that the corner (named as a panel-rear inner quarter) is part of the bodyside assy.

It doesn't show any fasteners associated with it though which would indicate that it may be welded in as I know that for instance the radiator support and inner guards mostly spot weld in but there are some bolted sections for mounts common to other panels and these fasteners are listed.

Originally Posted by Disco Muppet

I think Baz (Redback) replaced a rear panel at some point, perhaps shoot him a PM?

hehe, and scratched the new one shortly after...

***** of a job as need to remove all the internal bins and bits to get to the joins. good luck and await the tute!.

The wreckers are selling the entire side panel with side glass for $325 in the same colour as my d2.

RAVE says "The panel body side assembly does not require any welding, as it is bolted into position" pg 77-3-41

The seam sealing section of RAVE shows where the sealant needs to be applied - along the full length of the top of the panel and in several places under the wheel arch.



I've since had a look at mine and the sealant is visible just below the drip rail and has a coating of duco over it so will need repainting which sort of defeats the purpose of doing the job myself. I might as well suck it up and pay the $500 insurance excess on this one. I might be able to persuade the panel shop to blow some paint over a new bottom rear door hinge while it's in for repair.

cheers
Paul

From the D2 boys website. The fuel filler side, not the passenger side.

The D2 Boys Club. - Login

For $500- I wouldn't even attempt it. Might as well get it warranted.

Originally Posted by bsperka

From the D2 boys website. The fuel filler side, not the passenger side.

The D2 Boys Club. - Login

Interesting and it looks pretty doable but the last post really sums up the issue with diying it unless you have the means to refinish the seam sealing.

What did you use when reattaching the panel on the outside under the gutter to make it look factory fit???

It's going to look pretty ****ty if it's not done right.

I agree with clubagreenie, for 500 you will get some sort of warranty and less stress I have replaced/panel beated stuff of vehicles over the years and I can always see the imperfections in my work but not so much with a panel shops, unless it is glaringly bad! When done by a pro I always had the option of taking it back!