Thread: Oil Pressure Sensor - Wiring Plug

Did the plug break or was the wire pulled out?

I had the auto done on mine and it looks like this plug wasn't undone
The end result was the wire got pulled from the end of the terminal.
I repaired it by swaping the "spare" terminal over and joining the wires.
Maybe that's what the spare wire is there for

If it's the actual black connector that's broken then that's a different kettle of fish.
If you can't find a new connecter then do a search on here.
Not long ago a member changed out a full engine bay harness(wire rubbing issue).
If your lucky he may have a good plug on the old loom you could use.

I did drive it with the sensor undone, I had no oil warning light during this period though.
Obviously the ECU doesn't take a input for oil pressure or it would have gone into limp mode or shut down.