Page 4 of 6 FirstFirst ... 23456 LastLast
Results 31 to 40 of 51

Thread: Do I need a replacement performance radiator?

  1. #31
    Join Date
    Oct 2011
    Location
    Fremantle WA
    Posts
    3,839
    Total Downloaded
    0
    Andy - To whet the appetite.
    Off to Mandurah overnight in about 10 days for a shakedown cruise, then Boyup Brook to meet some friends at the C & W festival. In case you missed it the van link is a couple of posts earlier.
    Attached Images Attached Images
    D4 MY16 TDV6 - Cambo towing magic, Traxide Batteries, X Lifter, GAP ID Tool, Snorkel, Mitch Hitch, Clearview Mirrors, F&R Dashcams, CB
    RRC MY95 LSE Vogue Softdash "Bessie" with MY99 TD5 and 4HP24 transplants
    SADLY SOLD MY04 D2a TD5 auto and MY10 D4 2.7 both with lots of goodies

  2. #32
    Join Date
    Nov 2014
    Location
    Nirvana near Albany W.A.
    Posts
    2,483
    Total Downloaded
    0
    My god , if that has an indoor swimming pool , you could plumb in a heat exchanger to heat it via the poor old disco
    But if the rest of the cooling system is tip top , an 82 degree thermostat will give you some leeway , all the other stuff previously mentioned, is valid, fwiw ,I recently towed another d2 on a car trailer between bussleton and Albany on a 32 degree day and you know what the hills are like between , highest temp recorded was 91 degrees, this also has a tune , but when I know a hill is coming it's dropped in to 3rd lockup.
    Also when low speed towing eg leach hwy , hot day because of the low stall it means your fan won't be spinning as fast out of lock up as it normally would , so until you get your manual override it might pay to use the gears to keep the revs up to pull the air through
    Last edited by discorevy; 23rd January 2016 at 04:27 PM. Reason: more info

  3. #33
    Join Date
    Oct 2011
    Location
    Fremantle WA
    Posts
    3,839
    Total Downloaded
    0
    Not as big as it looks from taking a rear pic - its only a 20 footer after all - but does present a big front.
    I was in 3rd Sport driving along Leach H'way, but as Blknight says, with the bigger tyres not necessarily locked, remembering as you know that although I have a spped adjuster, its wheel speed that is read by the BCU to calculate lockup parameters. In my case for 4th lockup its 89 kmph - up from 80. 3rd lockup I never thought of checking before fitting the new tyres.
    So yes hoping the lockup over-ride will help.

    On the other hand, being facetious, if the oversize ATF cooler is doing its job, and there is still some slippage, the higher revs should aid with cooling the heat being created! Bit like a reverse perpetual motion.
    D4 MY16 TDV6 - Cambo towing magic, Traxide Batteries, X Lifter, GAP ID Tool, Snorkel, Mitch Hitch, Clearview Mirrors, F&R Dashcams, CB
    RRC MY95 LSE Vogue Softdash "Bessie" with MY99 TD5 and 4HP24 transplants
    SADLY SOLD MY04 D2a TD5 auto and MY10 D4 2.7 both with lots of goodies

  4. #34
    Join Date
    Oct 2011
    Location
    Fremantle WA
    Posts
    3,839
    Total Downloaded
    0
    I may have a lead. My EGTs are climbing! A normal, quiet acceleration up to 70 on the same rolling hills part of Leach H'way with no van = 450 degrees+. That's much too high.
    D4 MY16 TDV6 - Cambo towing magic, Traxide Batteries, X Lifter, GAP ID Tool, Snorkel, Mitch Hitch, Clearview Mirrors, F&R Dashcams, CB
    RRC MY95 LSE Vogue Softdash "Bessie" with MY99 TD5 and 4HP24 transplants
    SADLY SOLD MY04 D2a TD5 auto and MY10 D4 2.7 both with lots of goodies

  5. #35
    Join Date
    Aug 2006
    Location
    Melbourn(ish)
    Posts
    26,497
    Total Downloaded
    0
    while you're accelerating, thats acceptableish. if its sitting there while you're holding speed you're in trouble.


    that said...

    I can sit and hold 100KPH on the flat at 450 EGT
    Dave

    "In a Landrover the other vehicle is your crumple zone."

    For spelling call Rogets, for mechanicing call me.

    Fozzy, 2.25D SIII Ex DCA Ute
    Tdi autoManual d1 (gave it to the Mupion)
    Archaeoptersix 1990 6x6 dual cab(This things staying)


    If you've benefited from one or more of my posts please remember, your taxes paid for my skill sets, I'm just trying to make sure you get your monies worth.
    If you think you're in front on the deal, pay it forwards.

  6. #36
    Join Date
    Nov 2014
    Location
    Nirvana near Albany W.A.
    Posts
    2,483
    Total Downloaded
    0
    Free flow exhaust? enough boost?, map tune catered for low stall ,big tyres?

  7. #37
    Join Date
    Apr 2009
    Location
    South Sydney
    Posts
    2,499
    Total Downloaded
    0
    Thermostat won't change anything as everything is heat soaked anyway, it will only delay the inevitable by a small amount of time.

    Defender TC gearing is too low, unless you went to 33's (Defenders are geared lower than Discoverys, even after accounting for tyre size). I've run all the calculations. 3.75 or 3.90 diff gears are what you need (depending if you want to be slightly higher or very slightly lower than stock...). I even spoke to Dave Ashcroft about making a 1.3## high range, but he doesn't think there's a big enough market...

    Where is your EGT probe? Td5's run hot... especially if measured pre turbo, mine seems perfectly safe to sit in the low 600's on hills. Oil and compression tests confirm this. It is measured in front of number 1 exhaust port. But I think part of the reading is the flame artificially heating the probe to beyond the gas temperature. It's done 50,000km over 16 months set up like this. And it's fair share of towing. Yes I would like to cool it down, but it's coping well...

  8. #38
    Join Date
    Oct 2011
    Location
    Fremantle WA
    Posts
    3,839
    Total Downloaded
    0
    Quote Originally Posted by discorevy View Post
    Free flow exhaust? enough boost?, map tune catered for low stall ,big tyres?
    Ta. All on the list to discuss with DazzaTD5
    D4 MY16 TDV6 - Cambo towing magic, Traxide Batteries, X Lifter, GAP ID Tool, Snorkel, Mitch Hitch, Clearview Mirrors, F&R Dashcams, CB
    RRC MY95 LSE Vogue Softdash "Bessie" with MY99 TD5 and 4HP24 transplants
    SADLY SOLD MY04 D2a TD5 auto and MY10 D4 2.7 both with lots of goodies

  9. #39
    Join Date
    Aug 2006
    Location
    Melbourn(ish)
    Posts
    26,497
    Total Downloaded
    0
    Quote Originally Posted by MR LR View Post
    But I think part of the reading is the flame artificially heating the probe to beyond the gas temperature.
    If you've got flames coming out past the exhaust valves on a td5 then either a, somethings wrong, b, its hugely overboosted and fueled. and if you had flames coming out the exhaust valves, hitting the probe and you were only showing around 600 degrees your calibrations out, Id be expecting to see easily past 900.

    650 is your max safe sustainable EGT temperature (assuming the cooling system deals with the heat load)
    Dave

    "In a Landrover the other vehicle is your crumple zone."

    For spelling call Rogets, for mechanicing call me.

    Fozzy, 2.25D SIII Ex DCA Ute
    Tdi autoManual d1 (gave it to the Mupion)
    Archaeoptersix 1990 6x6 dual cab(This things staying)


    If you've benefited from one or more of my posts please remember, your taxes paid for my skill sets, I'm just trying to make sure you get your monies worth.
    If you think you're in front on the deal, pay it forwards.

  10. #40
    Join Date
    Apr 2009
    Location
    South Sydney
    Posts
    2,499
    Total Downloaded
    0
    Quote Originally Posted by Blknight.aus View Post
    If you've got flames coming out past the exhaust valves on a td5 then either a, somethings wrong, b, its hugely overboosted and fueled. and if you had flames coming out the exhaust valves, hitting the probe and you were only showing around 600 degrees your calibrations out, Id be expecting to see easily past 900.

    650 is your max safe sustainable EGT temperature (assuming the cooling system deals with the heat load)
    This is based on the fact that it reads stupid high at higher revs with lower throttle opening, either the map dumps lots of fuel (but it only rolls smoke at lower revs...) or it's getting flame bypass... Which being right bang in front of the port makes sense to me...

Page 4 of 6 FirstFirst ... 23456 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!