Reply With QuoteLike father like son !Originally Posted by DeanoH
Here's a pic from 10 years or so ago near Ballards Lagoon SA of the current owners father in the same vehicle.
bogged3.jpg
Deano
Master
Did oil pump bolt, new sump gasket, oil and filter change.
Bolt was tight but no loctite!!
ChatterBox
SubscriberLike father like son !
Here's a pic from 10 years or so ago near Ballards Lagoon SA of the current owners father in the same vehicle.
bogged3.jpg
Deano
OldBushie
SupporterIs there any reason why the vehicle could not have been driven forward in the first place thus preventing it looking like a stranded turtle and wreaking the front yard?
You only get one shot at life, Aim well
2004 D2 "S" V8 auto, with a few Mods gone
2007 79 Series Landcruiser V8 Ute, With a few Mods.
4.6m Quintrex boat
20' Jayco Expanda caravan gone
Master
Hope the house doesn't sink too
Master
Looks like you have had a run in with that famous earth moving contractor, Phil and his unreliable mate Con Pacshin.
ChatterBox
SubscriberHe will need to get the other two in , Con Pacright and Phil McCrackin
Master
SupporterIs that the first time u have checked it? How many kls is it on?
Mark
Discovery D2a 2004 TD5 auto (current)
Discovery 1 V8 1996 manual (gone)
Various series Land Rovers before moving to OZ
Master
Had D2 since Dec 2016, first and last time I'll need to check it
269000km
Master
SupporterYep it's next on my list once mine is up and running againHad D2 since Dec 2016, first and last time I'll need to check it
269000km
Discovery D2a 2004 TD5 auto (current)
Discovery 1 V8 1996 manual (gone)
Various series Land Rovers before moving to OZ
Master
Pretty easy to do, I needed to drop the tie rod off and have car up on chassis stands to get the axle hanging as far down to get the sump between the cross member.
Also needed to loosen the front coolant hose metal section and the auto lines and tied them clear of the front of the sump.
Replacing sump gasket I put it up on the block first, did the sealant across the rear main seal and front timing cover and then used some small cable ties in every second hole to hold the gasket in place.
Pretty sure there's a heap of tutorials on here, I've read a few used some of the tricks mention to make it easier.
Also used the cardboard template trick to number each bolt as removed then used that to do the correct tightening procedure as per RAVE
Cheers Lemo
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
AULRO.com Copyright 2001 - 2025 Independently Owned and Operated by Dave Blears Computing - DavecandoIT - AULRO.com LAND ROVER and its logo are the registered trademarks of Land Rover. Land Rover is not affiliated with AULRO.com. |
|
Bookmarks