Thread: LED flasher problem

G'day bmw535guy

Did you notice that I specified NARVA equipment and by Part No. I know the gentleman and the vehicle involved,we have been Land Rover owners and friends for over a decade now,and I worked in the automotive spare parts trade for over 35 years both Repco and Genuine BMC/Leyland.

cheers

Originally Posted by UncleHo

G'day Keith

Looking in my old NARVA cattle dog-2008--2010 I have a listing for a 3 pin LED flasher can 68253BL and a 4 pin 68254BL (which is the RRClassic 86-02) which might fit,the later NARVA catalogue 10-12 I am trying to get it has a much greater range of LED lights and flasher units,your local Repco will have a current cattle dog!


If not PM me and I will pop into my local branch (trade A/c)


cheers

Hi Kevin. Did not make it to ABD this year. Too busy with Doctors and Dentists etc. You know how it goes.
Got to go into town Friday so will try again .
However tomorrow I wil try a combination of resistors to see if I can get something to work.
Trying to get the camper ready to go to Glenreagh.

Originally Posted by gavinwibrow

Sounds like an excellent preventative maintenance idea. I wonder if these units still allow retention of the dash trailer light functionality for detecting blown bulbs (not that this "should" be an issue with LEDs)?

Or importantly also giving an indication that the indicators are working - ie cable to trailer attached.

Bob

Originally Posted by bobslandies

Or importantly also giving an indication that the indicators are working - ie cable to trailer attached.

Bob

thats part of what I meant - GRIN!

Originally Posted by UncleHo

G'day bmw535guy

Did you notice that I specified NARVA equipment and by Part No. I know the gentleman and the vehicle involved,we have been Land Rover owners and friends for over a decade now,and I worked in the automotive spare parts trade for over 35 years both Repco and Genuine BMC/Leyland.

cheers

Just thinking back its over two decades getting on to three
We were at the Len Beadell lecture too and in fact camped the nights in the Uni grounds as it was too late to drive home.
Got sprung by security but I said my headlights crapped out so had to wait till morning to fix them. This was in the old 2B camper.

Well hooking up the two Narva resistors in series then connecting that lot in parallel with the led slowed the rate down to acceptable limits.
The other highmount leds and the side led,s all flashed brightly except the new one mounted lower, its a bit dull. I put this down to me buying an ebay cheapy instead of a name brand.
So I need a total of four resistors . Two each side.
I also contacted Hella and they suggested flasher 3036 and sent a spec sheet. Its for LED,s and bulbs and matches the landy wiring except for a spare pin as its 5 pin not 4.
Thats not a problem either as the spare pin C2 is the same as C which are for the trailer pilot.
Instead of mucking anymore with resistors I will bite the bullet and order this and it may bring the other leds brightness up a bit.
The downside is they cost around $120.00
I asked Repco about Narva and they said they could not find one that would do the job.

Keith