Thread: Dual Battery and Air Compressor in D4

I have put mine in the same spot as Rollin over. But mine is the new CKMA12 offered by ARB. my plastic cover goes back on as well. Moved a bit of wiring and the plastic case the covers the transfer case module was trimmed on the base to allow the compressor to sit low as possible. The rubber grommet at the front right side of plastic housing was perfect spot for the switch. Once I figure out how to post pics using my iPhone I'll put some up.

Billy

Originally Posted by thomasb

Baz ...one other question re the drawers ........my lower tail gate is a bit angled up so i had to pack up under the drawers to get clearence of the lower tailgate ........
i notice your drawers dont seem to have much packing under then (i sheet of ply ?)

is there any way to adjust the lower tailgate get to get it compleatly level rather than slightly angeled upwards

sorry to intrude into this tread .....but i saw your drawer fitting and it has helped me a lot

Not that I know of, I have a false floor and an 18mm sheet of ply under the drawers, the bottom of the drawers are 15mm, that lifted them enough, but they still touch the tailgate when they are fully open, these are from my old D2, so I'll be making a new set soon, I am trying to work out an easy way to angle mine as well.

Baz.

thanks Baz ........let me know if you come up with a solution to the angle problem

My install,hope photos workBilly's Iphone 197.jpg

Billy's Iphone 198 (Medium).jpg

Billy's Iphone 199 (Medium).jpg

Had to move the wiring harness a little bit, also had to trim down the base of the mounting bracket that contains the bosch module for transfer case.

All and all happy with install

With cover on.
Want to run a hose to the back eventually so when I/m towing camper trailer i can inflate those tyres as well.

Billy's Iphone 200 (Large).jpg

Cheers all

Billy

Nice job,

Thanks Billy

Gup

Originally Posted by Canaussie

My install,hope photos work

Had to move the wiring harness a little bit, also had to trim down the base of the mounting bracket that contains the bosch module for transfer case.

All and all happy with install

After seeing this I have gone out and brought one now to fit?... Haven't really got any idea where to start could you give us a heads up maybe step by step that would be great.

Thanks.

Originally Posted by the_amors

After seeing this I have gone out and brought one now to fit?... Haven't really got any idea where to start could you give us a heads up maybe step by step that would be great.

Thanks.

This should help http://www.aulro.com/afvb/d3-d4-rrs/...tery-tray.html. It took me 40 mins to clear the entire 2nd compartment area for my Optima D34 second battery using a Traxide kit. As an air compressor is much smaller all these steps won't be needed. I have my air compressor (ARB brand) mounted in front of the cranking battery.

Regards Trif.