Reply With QuoteCharge your battery, do a hard reset and it will probably be back to normal.
D3 stuck on it's guts
So yesterday evening I had to change the front prop shaft in my 05 LR3. All mechanical stuff went according to plan, however, I left the ignition on the whole time and the battery went flat. After getting the car going again (jump started it off my old mans LR4) I am getting a suspension error and it won't lift up from it's lowest setting.
I have a llams kit which I have switched off and tried several times to clear the codes with my nanocom, but the fault still comes back.
I had it in super extended mode (so I could fit under the truck) while I did the work so I don't think it could be a leak.
Is there something I can do to reset the suspension? It still drives normally, except for excessive bouncing on the bump stops.
If you could point me in the right direction or share some information, It would be muchly appreciated!
Master
Charge your battery, do a hard reset and it will probably be back to normal.
Swaggie
Are the raise and lower LEDS flashing? If so, press the raise button.
What fault does the Nanocom show?
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
Battery has been charged. Sorry for my ignorance, but what is a hard reset?Originally Posted by Epic pooh
I've just disconnected the batteries to double check they are properly charged.
I can't remember if the lights were flashing, I will check again when I connect the batteries up again.
The light on the dash that has been orange when other faults occurred has turned red.
I'll hook the batteries up and check again.
Swaggie
You will need to get the fault codes.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
The lights aren't flashing. There is a red one on the dash.
I got a control module error on the nanocom and a c431 error. The rear is going up and down but the front is stuck at the lowest setting
Swaggie
When did you get the Llams? If it was before about April this year then it needs a cable-tie to hold the 2 grey connectors together. Those connectors are for the front so suggests a possible cause but nothing to do with the work just completed or a flat battery.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
I can't remember when I bought it, but I've only had the car for a bit over a month.
I've run out of light and organised a hire car to get to work tomorrow. Will have another crack at it tomorrow arvo. Might take the llams out and see if that does anything.
Swaggie
Removing Llams will reduce the number of possible causes, including the remote possibility of the IC for the front sensors having been damaged during the jump-start.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks