Thread: My Review & Experiences of Bluespark Pro + Boost Tuning Chip

Originally Posted by BeeJ

. Maybe this community just isn't as open to new ideas or something different.

its not about being into new ideas or something different.
its about correct knowledge and application.

this community is a wealth of knowledge.

at the end of the day, all that matters is your happiness.
take our advice, dont take our advice, its your car, your money.

Originally Posted by Eevo

its not about being into new ideas or something different.
its about correct knowledge and application.

this community is a wealth of knowledge.

It certainly is for somethings but I couldn't find any information on any chips on aulro. I believe it's short sighted to say that is because there is no such thing as a good chip. Theyre not all a resistor in a plastic box

Like I posted earlier simple google search on reputable brand chips reveals a wealth of positive experiences and results.

Originally Posted by BeeJ

I believe it's short sighted to say that is because there is no such thing as a good chip.

i've got a bridge to sell you. on the other side of the bridge is a snake oil factory.

Mine had a Steinbauer when I bought it and so far no problems.

Steinbauer claim up to 20 percent improvement and not to overstress engines. I'm no expert so others can comment on that.

Originally Posted by DiscoMick

Steinbauer claim up to 20 percent improvement and not to overstress engines. I'm no expert so others can comment on that.

Awesome discomick
I have heard goo things about Steinbauer

Guessing you like snake oil too

A few references of longer term experience:

Bushtracker Forum :: View topic - WARNING ENGINE KILLER PERFORMANCE INCREASE ON TOYOTA ENGINES

Why No Diesel Performance Chip | outbackjoe

Put simply - any tuning will reduce engine longevity - by how much depends on how it's done, to what extreme etc.

It comes down to how long you intend to keep the vehicle, what loads it's placed under during your use, and how it goes about doing it.

If you aren't completely modifying to signals for timing, boost, injector pulse width etc then you are doing your engine a complete disservice.

Just winding the Rail pressure up stresses the pump, adds pre-ignition to the engine and runs it hotter.

The TDV engines are multiple pulse, having these timed correctly is critical to keeping the thing alive.

An hour or 2 on a Dyno will never be satisfactory for all occurrences.

Changes to Smoke Adjustment tables, high load, high ambient etc are all required to keep the engine in check. A box can not do this.

That box has $20 worth of parts controlling a $18k engine... and a fixed table - if x=? Then y=? Regardless of temperatures etc.

Even a "generic" tune has had significant dyno time - usually hundreds of hours - to modify more than the base fuel table.

The cost comes into the research, the tools and the IP related to the adjusting of smaller tables within the ECU resulting in a smoother, low stress tune.

As a side note: I no longer tune engines - gave up years ago - to time consuming with other work commitments...

There's a lot invested into making it happen correctly - get it wrong and engine wear increases are significant.

Will they show up during the time of ownership for the person who had it done? Can't be certain... but I would certainly avoid buying any vehicle I found to have been fitted with a Box over a professional remap.

Having said all that - if you're happy with how yours goes - and with no EGT, no regular boroscope checks and no oil analysis etc you won't ever know... until the day it needs a tear down...

A prime example of bad tuning is a TD5 owned by a member of this forum... he had a poor tune fitted which destroyed the engine in under 6 months. He now has a rebuilt engine with a full remap - all the sub tables correct this time - and it's showing no anomalies in oil analysis for excessive wear etc.