Thread: Clunk in front suspension

Originally Posted by PerthDisco

It's 32mm I think the hub nut. Should not be reused I believe. It must be a common size as 32m sockets are easy to find in tool shops.

Did you just use the sliding movement in the outer CV or actually open the boot and split it thereby needing a new clamp for the boot?

I found that if I let the inboard arm ends drop to the ground, with a bit of wriggling, I could get the swivel end ball joint clear of the swivel hub without damaging the CV boot. You lay the ball joint over at an angle as it comes out of the hole to let the arm clear the CV boot.

I never understood the reason for releasing the hub nut and pushing the shaft back. Is it all about clearance for the LCA?

Originally Posted by PerthDisco

I never understood the reason for releasing the hub nut and pushing the shaft back. Is it all about clearance for the LCA?

Makes it much easier to remove the lower ball joint out of the bearing housing arm thingy. No clearance on the outer CV joint.

And was the rear bolt difficult to remove?

Originally Posted by PerthDisco

And was the rear bolt difficult to remove?

The rear bolt on the LHS is only difficult to remove as the Cat sits right behind the nut so a deep socket will not fit. I would usually use my breaker bar to crack the nut loose, but a 24mm ring spanner was all I had that would fit it. Due to the length of the large spanner and the low height I had the vehicle on stands, it would not swing through any reasonable swing without hitting the ground. It was also difficult to get anywhere near the correct torque when tightening, but I was not too concerned about this as I knew the bolt would be disturbed again during the wheel alignment the next day. Setting the vehicle much higher on the stands would have alleviated most of these issues.

But the bolt was not seized frozen in the bush?

Originally Posted by PerthDisco

But the bolt was not seized frozen in the bush?

No mate. Other than the swivel tapers being hard to split, all other bolts were easy to tap out. I had heard that seized bolts could be an issue but I had no issues.