Reply With QuoteHi Laurie, all wire sizes are Xmm AUTO.
4mm AUTO = 1.9mm2
5mm AUTO = 2.8mm2
Master
SubscriberTIM,Originally Posted by drivesafe
The diagram shows wiring sizes. Are these the actual wire cross section 5mm square or just general wire size you see on the roll?
All the best,
Laurie
2019 sd6 SE
2012 SDV6 SE (Son stole it from me)
OldBushie
Hi Laurie, all wire sizes are Xmm AUTO.
4mm AUTO = 1.9mm2
5mm AUTO = 2.8mm2
Fossicker
Supporterhow/ where do you tap into the high beam circuit? where is the factor high beam relay?Yes, you need to tap into the high beam circuit
where is the fuse for the front lights?
and is there a separate fuse for the high beam relay?
cheers
Ray
TopicToaster
SubscriberI tapped into it at the headlight, putting the relay nearby. Given the battery is nearby as well, it all remained local. The only remote thing to run was the switch into the cabin
In my case I cut the wire, added some glue impregnated heat shrink, soldered it back up and sealed it watertight. I didn’t want to use tape or a connector.
2010 TDV6 3.0L Discovery 4 HSE
2007 Audi RS4 (B7)
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks