Printable View
Hi Tim,
The packaging has already gone in the bin, but I think it was a generic name like 'AUTO-LED'. We bought them from a local trucking supplier in Wetherill Park called 'Big Rig' , but there would no doubt be similar suppliers in your area.
You may have to address the rapid flashing if you are replacing standard 20 watt globes with the LEDs.
Cheers, Erich
Got back from the South Coast a short time ago and we are quite happy with the performance of the 130.
We did 360ks. - about half of that on freeways at around 120kph - went down the Princes Hwy, and came back through Kangaroo Valley. Our fuel consumption was 12.1 litres /100kms
Tomorrow the eyelets are getting put on the canopy so it can be tied down nice and firmly.
Erich
Work in progress on the quad bike trailer which we will be towing up with us. Picking up Alfred's new Honda quad in Darwin and taking it out to Gapuwiyak.
http://img23.imageshack.us/img23/8395/nov16027.jpg
Erich
More pictures of the old green pick up please Erich...??:D
Do you mean the jail bar Ford? That is my nephew's daily driver. I will try tomorrow if I get over there.Quote:
Originally Posted by Lucus
Erich
Oh No
where is my daily fix, I'm thinking maybe you guys should pull it all apart and do it again. I think you may have missed something
cheers
blaze
Quote:
Originally Posted by bblaze
Thanks for your and everyone's interest.
It is not that we aren't working on the car. Just not enough time to post amd take photos. I have just finished for the day - earlier than normal and will add a bit shortly
Erich.
2 days to go.
Today we completed the trimming of the rear cover with the installation of hold down clips. These were done by a trimmer. Also added eyes in the corners to hold out the tarp for shade
http://img33.imageshack.us/img33/2784/nov18012.jpg
Also did many smaller overdue jobs like:
replacing the injector loom (we found some oil in the ECU plug when working in that area) I suspect this has already been changed but don't want to take the risk.
http://img684.imageshack.us/img684/5081/nov18011.jpg
Replaced the idler pulley bearing - smallest noise
http://img258.imageshack.us/img258/8644/nov18007.jpg
replaced the fan belt
Replaced missing screw clips at the top of the fan shroud
drained the water from the system again and refilled
Repaired a leak at the pipe out of the centrifical oil filter housing - didn't do it up correctly last time
Replaced front wheel bearings, seals, nuts etc on both sides and installed Maxi type caps. Also attempted to stop brake squeel - haven't test driven yet to see of this was successful
http://img684.imageshack.us/img684/4097/nov18009.jpg
Built a fridge slide for Sharon's Trailblazer 60 litre fridge
http://img684.imageshack.us/img684/7011/nov18015.jpg
Also working in progress on some stays for awning shade
Added the tow bar and lots of small odds and ends
Erich
Have been quietly following your progress with great interest. To everyone involved: what a great job. Well done.
Have a safe trip and all the best.
Cheers, Martin
An area which may have gone unnoticed is the small cover at the base of the headboard which hides a storage pocket going right across the tray, with a hinged cover on both sides. We are going to store poles for tarp shade in this compartment. (needs a clean!)
We used stainless screws where ever possible, as can be seen in this pic.
http://img109.imageshack.us/img109/4394/nov18003.jpg
Erich