Thread: Show us your S1.

Hopefully this is some help...

(opps!! sorry too big to download!)

PM me your email address and I'll send you the operation manual (1950) on a PDF file. and whatever else I can find for your vehicle. Mine is a copy via an o/s website, but I believe better copies etc though are avaiable on the RAVECD in daves shop.

Cheers
Digger

Hi Digger,

I have the Land Rover Operartions Manual (1950) but no mention of the starting handle, although it does show location of the wheel brace handle (N).

Numpty, Thanks for the advise on location of the starting handle, will check out Lionel on our next visit. I guess it must be behind the spare wheel. The 13th National Historical Machinery Rally is coming up this coming weekend in Pinjarra so hopefully will check some series one's out. Wish I had known about this earlier.

Cheers Nigel

Originally Posted by Avion8

Hi Digger,

I have the Land Rover Operartions Manual (1950) but no mention of the starting handle, although it does show location of the wheel brace handle (N).

Numpty, Thanks for the advise on location of the starting handle, will check out Lionel on our next visit. I guess it must be behind the spare wheel. The 13th National Historical Machinery Rally is coming up this coming weekend in Pinjarra so hopefully will check some series one's out. Wish I had known about this earlier.

Cheers Nigel

On my '56 and on 2/2a's its behind the seats on the front of the tray (seat side) I believe this was the same for the early ones, Havent looked at either my 49 or 53 trays so cannot tell you (sorry) but will look tomorrow-- arvo!

cheers
Digger (also a Nigel!)

Clips no 32 are for starter handle.Clip 31 forjack handle

Thankyou B.S.F. Nut,

I have the holes but non of the clips. But at least I now know where it all fits. Thanks for your assistance.

Hi All

Sorry to be a pain, but on some of the very first 80"'s the crank handle was clipped inside the engine bay along the side of the inside panel of the mudgard.

Cheers Arthur

Scallops, well done, I hope to meet up at the GCLO event, here is noddy a 57 or 58 currently in under restoration
Facebook

Facebook

Facebook

This is my 49. into dispatch 9/5/49









R8665576 is quite original as well with most of its original running gear. Here are the numbers and dates.

Chassis R8665576 build No 5701
engine 865695 build date 13/4/49
Gearbox 865612
rear diff 865680
front diff 865645
PTO 860322 10 spline
Pulley 860152 10spline
Rover Clutch pressure plate and oil slinger
choke switch 2/49
dynamo 3/49
Regulator 4/49
Radiator 4/49
Tail lights 11/48
Starter motor 10/48
Amp meter 11/48 20/20
Distributor 4/49
Glass 1st quarter 49
Fuse box 4/49
Stop light sw 3/49
5 4.5 inch wheels 48-49
Flat 4 spoke steering wheel


Cheers Richard