Thread: Leaf hanger bushes- removal?

Use an oxy to burn out the rubber - removing the rubber and inner tube.
Then use a hacksaw with the blade inverted to cut through the outer shell carefully. (I usually make 2 cuts then use a chisel to remove the strip of metal between the cuts)

...or...
Someone VERY skilled with a gas axe can cut the outer shell out without damaging the chassis...

Hacksaw (as mentioned by Isuzurover) and/or make up an extractor, both shown in this thread Getting the Series 1 Ready for Cooma

I'm not keen on burning out the rubber, used coarse hacksaw blade to cut through it instead.

Best of luck.


Colin

cheers guys, will dig out the hacksaw tomorrow and have a go

I've used both methods described above and much prefer burning the rubber out as it is so much quicker.

I found using an electric drill with a drill bit sligthtly smaller in diameter than the rubber thickness,drill through the rubber all round the bush then knock out the centre piece.Also two hacksaw blades together in the hacksaw will give you a wider slot and with a cold chisel close up the slot and the outer metal bush should come.