Shane you are doing a good job with your chassis repairs and removable centre cross member.
Are you going to fill the front cross member back in where it has been cut to allow the radiator to move forward?
Keep up the good work.
Cheers, Mick.
Printable View
Shane you are doing a good job with your chassis repairs and removable centre cross member.
Are you going to fill the front cross member back in where it has been cut to allow the radiator to move forward?
Keep up the good work.
Cheers, Mick.
Hi Mick.
Watch this space.
Gav, I never bet on anything, but a fun challenge, I'm up for it.
Looking forward to my Tooheys Old. 😎
Whitehillbilly
Mmmm, Tooheys Old - I'll have to sit down and share one or two... :)Quote:
Originally Posted by whitehillbilly64
Close to finishing rear cross member.
Then Blew a hole which 'grew' as I tried to weld.
Had to cut and put in a small square patch.
whitehillbilly
Adding a few 1 inch Drain/flush holes that will plugged by Gromits.
1, front and rear, chassis rails and one on each Bulkhead out riggers.
Also a couple extra in chassis rail.
I plan to spray, something, and at least I can get a tube with spray head, front to rear, once or twice a year on the inside.
What do members use ????
Thanks.
whitehillbilly
Fishoilene or Lanertex. Don't use oil it will forever leak out of the chassis.
Thanks Landy,
will look into those.
Crush tubes in removable GBox cross Member, and Tacked in.
1/2 inch bolts.
More pics tomorrow.
whitehillbilly
Had cutter disk on grinder, so cut open, middle cross member. [bigsad]
Lots of patches.
whitehillbilly
Inside the cross member.
whitehillbilly
Free iron rich fertiliser maybe?
Cheers,