Reply With QuoteCan be done in the vehicle. Don't leave it for too long, as the more you drive it, the more it costs....
JC
YarnMaster
i have a mad whine in 5th gear at cruise so not under power or on over run just at cruise in 5th im assumeing its a claged bearing allowing **** gear mesh is this going to be an easy fix or total over haul the trans is silent otherwise
Swaggie
Can be done in the vehicle. Don't leave it for too long, as the more you drive it, the more it costs....
JC
The Isuzu 110. Solid and as dependable as a rock, coming soon with auto box😊
The Range Rover L322 4.4.TTDV8 ....probably won't bother with the remap..😈
YarnMaster
what bearing is it that fags out?
Master
The 5th gear noise is most likley caused by the undersized support bearing fitted to the rear of 5th gear. I 'borrowed' some pics so you can see where it is. It is the small bearing in the second picture - don't get me started on how dumb this is!
This bearing delaminates (hard facing comes off) causing grating or whining and often can be the only thing wrong in the box. If caught early enough is a cheapish fix, if left; well bits of bearing material end up everywhere.
I have not replaced on the vehicle as yet as others have advised so best of luck.
Toad.
Swaggie
And I have seen one where after the bearing eventually failed and the owner kept driving it, the shafts were spread apart enough to strip teeth off the 5th gears. THAT was a fair bit more expensiveOriginally Posted by toad
JC
The Isuzu 110. Solid and as dependable as a rock, coming soon with auto box😊
The Range Rover L322 4.4.TTDV8 ....probably won't bother with the remap..😈
YarnMaster
well i can see its a fairly **** poor bearing im fairly handy with the tools can it be done with out pulling the whole lot out or am i just ****ing in the wind if i can rip the tbox out and get to it would be great.
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks