i did the maf 2 days ago, there was no differance at all in idle or performance, unlike when it died the first time the auto shift was crap and performance dropped a bit.
something that may be related is in the nanocom there is a value given for torque. when my ecu and the other was read both values were quite different. it was read from the abs/sls section of the nanocom and after reading this from the rave i wonder if its actually relating to the auto?
CAN communications between EAT ECU and ECM
Inputs from ECM Outputs to ECM
CAN version identifier Calculated gear
Emissions (OBD II) control Diagnostic information
Engine air intake temperature Emission (OBD II) fault status
Engine speed Engine torque reduction request
Engine speed fault flag Gear position switch information
Engine temperature Output shaft speed
Engine torque Mode information
Engine torque fault flag Shift information
Friction torque Torque converter lock-up status?
Maximum engine torque
Reduced engine torque
Road speed
Status of engine torque reduction
Throttle position
this is the screen shots from the nanocom, note the top is the good D2 and the other is mine. these were botained with the ignition on, engine not running.
Attachment 30187
mine shows way higher engine speed and low torque, opposite for the good D2?
cheers phil

