Results 1 to 4 of 4

Thread: 2.25 engine rear oil seal replacement

  1. #1
    Join Date
    Jun 2011
    Location
    Rocksberg, Qld, Australia
    Posts
    8
    Total Downloaded
    0

    2.25 engine rear oil seal replacement

    I am in the process of fitting a new rear crankshaft oil seal to a 3 bearing 2.25 Petrol engine. Does the seal get compressed to about half its original width by the seal retainer plates? The Haynes manual isn't very informative and I think the previous oil seal was fitted incorrectly.
    Can anyone give me a bit advice on the correct method of installing the rear oil seal?

    Lachlan

  2. #2
    Join Date
    Dec 2006
    Location
    Narrogin WA
    Posts
    3,092
    Total Downloaded
    0
    My S2 manual lists 32 steps to replacing the seal correctly and it appears that there must be at 32 ways to install it incorrectly as well!

    Unfortunately they are far too complicated to list here and I am not sure how to post a scanned page. If you PM me I could send a scan to you or alternatively buy the Rover manual,

    Cheers Charlie

  3. #3
    d@rk51d3 Guest
    Scanned from the LR manual.............
    Instructions for 2 piece and 4 piece seals.










  4. #4
    Join Date
    Jun 2011
    Location
    Rocksberg, Qld, Australia
    Posts
    8
    Total Downloaded
    0
    Thanks for the help

    Lachlan

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!