Disco Fan Tool 2001 TD5

**trog** · 8th November 2011, 05:09 PM

you can aways cheat . get the rad out for a clean and check then ask if the i c can be done at the same time. i was lucky as the nat rad dude said "why not " no extra charge !

**Xtreme** · 8th November 2011, 05:32 PM

A hack saw and a drill and you can make something like this -

The handle on the 'spanner' is 20 x 20 SHS slotted to fit the jaw section which is cut from a piece of 6mm flat.
The 'locking bar' is 20 x 5 flat with appropriate size holes drilled in the end to fit over the 10mm heads of the fan bolts.

**flyreels** · 8th November 2011, 06:18 PM

Originally Posted by OffTrack

I picked up a set of spanners from Diff Lock in the UK. They are heavy so the shipping (£45 to Melbourne) pushes the landed price up considerably. I don't have access to a workshop to fabricate the additional bits and pieces to hold the fan so the set represented good value.

4x4 Store

Hi I also got the set of spanners from Diff Lock in the UK and the prop shaft tool, A-Frame ball joint driver and the Hub Nut Spanner – tommy bar and 3/4 drive and the shipping was £45 for everything to Tassie so it made it more cost effective.
Cheers Peter

Thread: Disco Fan Tool 2001 TD5

Thread Tools

Bookmarks

Bookmarks

Posting Permissions