Results 1 to 5 of 5

Thread: T-Case front output shaft movement

  1. 5th November 2013, 07:14 AM #1
    weeds's Avatar
    weeds
    weeds is offline Swaggie
    Join Date
    Feb 2005
    Location
    Bracken Ridge - Brisbane - QLD
    Posts
    14,276
    Total Downloaded
    0

    T-Case front output shaft movement

    on a 300tdi, how much movement in the front output shaft would you expect?

    the last few times i have engaged CDL in high range there has been a vibration when i back off or there is over run......

    when i was greasing the drive shafts i noticed some vertical movement in the drive flange

    i will invstigate a bit more tonight

    should there be any movement?
    Reply With Quote Reply With Quote
  2. 6th November 2013, 12:36 PM #2
    460cixy's Avatar
    460cixy
    460cixy is offline YarnMaster
    Join Date
    Oct 2006
    Location
    canberra
    Posts
    3,002
    Total Downloaded
    0
    Shouldn't move but I have seen them with a fair bit of movement and still not give any trouble
    Reply With Quote Reply With Quote
  3. 6th November 2013, 01:01 PM #3
    weeds's Avatar
    weeds
    weeds is offline Swaggie
    Join Date
    Feb 2005
    Location
    Bracken Ridge - Brisbane - QLD
    Posts
    14,276
    Total Downloaded
    0
    Quote Originally Posted by 460cixy View Post
    Shouldn't move but I have seen them with a fair bit of movement and still not give any trouble
    a bit of research last night indicates there is some movement......

    can this be adjusted?

    i might pull the front prop sharf off and check the nut on the flange

    thanks for your reply......was starting to think nobody had experienced this issue
    Reply With Quote Reply With Quote
  4. 6th November 2013, 01:07 PM #4
    Psimpson7's Avatar
    Psimpson7
    Psimpson7 is offline TopicToaster
    Join Date
    Sep 2007
    Location
    Gold Coast
    Posts
    6,078
    Total Downloaded
    0
    Kelvin,

    There will be some movement just in the nature of the bearing design and assembly. If the flange is tight and the bearing is good you cannot remove it. (the slight amount of play that is)

    Rgds
    Peter
    Reply With Quote Reply With Quote
  5. 6th November 2013, 02:13 PM #5
    460cixy's Avatar
    460cixy
    460cixy is offline YarnMaster
    Join Date
    Oct 2006
    Location
    canberra
    Posts
    3,002
    Total Downloaded
    0
    The bearing can be replaced in situ if its claged LT230 Output bearings & Oil seals:
    Reply With Quote Reply With Quote
« 300Tdi Random overheat | leaking kick down cable zf4hp22 »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!