Thread: low water alarm

as requested.


here you have the modul, prob, and brass ring
the modul has a busser on it's lid and the 4 wires out it's base. yes it's a film canister.


instructions
<div class='quotetop'>QUOTE</div><div class='quotemain'>
4 Wires
1. acc.
2. probe
3. earth
4. Horn, buzzer, light ???
the probe can go into your header tank or the upper tank on the radiator. If eather is plastic you have to fit an earth to the tank at the same level as the prob. (below the low water level) The brass ring is for soldering on to a metal tank. The buzzer will sound if the water fulls below the probe.[/b][/quote]
This is what I'm using, I brought it from Brisbane. (I do not sell or make this)
I'm going to fit it to in the top radiator tank, where the plastic plug (#NTC4609) which is now a brass plug supplied by Maxie Drive (gold coast)

As for my gear temp gauge looking at running it throught (#PRC7984) [Switch transfer box temperature sensor]. witch only runs a light at the moment. use a T pice to fit two sensors.

Nope not hard at all.
once you know which code line to use.

[img]style_emoticons/<#EMO_DIR#>/biggrin.gif[/img]