Front wheel bearings on a Series 3

**Phoenix** · 3rd February 2005, 08:29 AM

I was hoping it was as easy as just hammering it back in carefully. I was a bit cautious about trying without asking, no point ruining a perfectly good part.

A brass drift might be a worthwile investment though, the cold chisel I used to take the runners out of the hub (which had already come off the vehicle), probably wopuldn't be the best way to remove them :wink:

Hellspawn · 3rd February 2005, 05:44 PM

Why do you say that ? Most people use cold chisels for most things on Rovers !! 8O [img]style_emoticons/<#EMO_DIR#>/laugh.gif[/img]

Yeah brass is the better way to go.

Grease.....? Grease...? hang on aren't yours oil fed ?

My hubs are full of Molydi' grease if you want to go that way..... least they don't leak [img]style_emoticons/<#EMO_DIR#>/biggrin.gif[/img]

**Phoenix** · 4th February 2005, 07:53 AM

Swivel hibs are oil filled as per usual, but my bearings are regular greasers :wink:

Thread: Front wheel bearings on a Series 3

Thread Tools

Bookmarks

Bookmarks

Posting Permissions