Page 2 of 2 FirstFirst 12
Results 11 to 18 of 18

Thread: New Gadget for your defender - Throw me some input.

  1. #11
    Join Date
    Jan 1970
    Location
    Adelaide Hills - SA
    Posts
    12,486
    Total Downloaded
    0
    And outside Temp too....

  2. #12
    Join Date
    Aug 2006
    Location
    WA
    Posts
    13,786
    Total Downloaded
    0
    Water sensor for the fuel sedimenter - also connected to an alarm.

    For those of us who want to burn chip fat (SVO), a fuel temperature sensor and a feed to power an electric solenoid valve once the svo tank gets to a preset temperature.

  3. #13
    Join Date
    May 2006
    Location
    Yack
    Posts
    1,388
    Total Downloaded
    2.78 MB
    Oh ........ and a hot chick alarm ..... I usually miss them when Annettes not there to point them out[/QUOTE]

    Schmezz..does annette read your posts!!! Does she really do that for u??
    If so I am very impressed.
    Edddo

  4. #14
    Join Date
    Aug 2006
    Location
    Bexley NSW - Sydney
    Posts
    502
    Total Downloaded
    0
    -- What about a turbo pressure readout? PSI or Bar.
    Nup, there is no electronic signal with the boost presure (or is there?)

    - Tacho
    Nup, again there is no signal to pick up (again ... or is there?)

    - Clock (everything's got a clock nowdays!)
    Look at your wrist .. mine has 2, one of the Radio and the one where the tacho should be (tight **** LR)

    - Cabin temp (so SWMBO doesn't complain to much)
    Nup, open the vents if its hot, no use knowing how hot you are unless there is something you can do about it.

    - And outside Temp too....
    Hmm Nup, like cabin temp, why would you need to know this, just get outa the car, if its hot, its hot :-)

    - Water sensor for the fuel sedimenter - also connected to an alarm.
    Car has one already doesnt it ? it lights up when all goes bad ? or when you replace it and all goes bad eh rob?

  5. #15
    dmdigital's Avatar
    dmdigital is offline OldBushie Vendor

    Gold Subscriber
    Join Date
    Jun 2006
    Location
    Arnhem Land, NT
    Posts
    8,492
    Total Downloaded
    0
    Tacho - The pickup is from alternator.

    Clock - I wasn't really serious on this one, but you must admit every bloody electric gadget has a clock display on it.

    Cabin/Outside temp - Never gets cold enough in the top end to worry about so I don't mind if you leave it out. Need 2 settings. Hot and Don't get out of the car
    MY15 Discovery 4 SE SDV6

    Past: 97 D1 Tdi, 03 D2a Td5, 08 Kimberley Kamper, 08 Defender 110 TDCi, 99 Defender 110 300Tdi[/SIZE]

  6. #16
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,041
    Total Downloaded
    0
    Add an oil pressure alarm.

    My home-grown unit sounds its alarm if there's no oil pressure, although it doesn't do it until there's already been oil pressure (after engine startup) . It also sounds its alarm if there IS oil pressure (faulty switch) prior to engine startup, but only for 5 seconds in case the driver needs to drive the vehicle even with a faulty switch.

    I suspect that your dad does PIC or PICAXE programming.

  7. #17
    Join Date
    Jan 1970
    Location
    Yass NSW
    Posts
    7,239
    Total Downloaded
    0
    Maybe allow a fuel guage so if you have a water tank you could plug it in to tell you how low you are. Otherwise sounds good.

  8. #18
    Join Date
    Jul 2011
    Location
    perth
    Posts
    252
    Total Downloaded
    0
    Quote Originally Posted by Cameron_Def View Post
    After seeing a few things on the net, I descided to throw my old man a task (he plays well with eletricalthingiemagigs) so this is what is we have started with...

    He is designing and build me a thing, lets call it "doodaa Mark 1"

    All information will be displayed on a 16x2 backlit display (dimming with lights being turned on) with 2-3 control buttons. It will be designed to sit at the base / or around the cubby box on a Defender.

    I am really keen to get a 1 box solution for most of the controllers / sensors that we as 4wders need / can use.

    It will be, and be able to do,

    - Full electronic Turbo timer
    --- Using Auto sensing Turbo heat, adjusting timing period on the time driven and heat
    --- Bypass button
    --- Adjustable cool down period
    - Turbo Monitor & Temp alarm (Able to Set / High Low Setting)
    - Engine Monitor & Temp alarm (Able to Set / High Low Setting)
    - Battery Voltage Levels (x2 Batteries) .. and alarms

    Other things we are talking about but not definate yet
    - Fridge Temp
    - Duel Battery controler <--- Doubt it but very possible

    I am still looking for more ideas ?? what else would you like to know about / control ?

    And no we can not monitor, oil in the harness, oil pump bolt settings, head warping or fuel pump status (LOL!)

    Once these are finished, and if there is some interest, we will be looking to produce some for sale to AULRO ...

    But I am really interested in other ideas that we can put into this product!
    Was this ever made? It sounds a lot like the madman Ems units.

Page 2 of 2 FirstFirst 12

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!