Thread: Depressurising rear Airbags.

Jack up the chasis on one side and then undo the nut with the air line thorugh it going into the top of the airbag. You will get to a point where air starts to escape. let it go for a while and keep loosening it until all the air has escaped and you have removed it from the air bag.

You can now undo the top clips and twist the bag to release it from the axle housing. Install your kit for that side, refit the air bag, paint the airline nut thread with number 3 aviation gasket and screw it back into the air bag.

Then lower the chasis jack so the body was sitting right down on the air spring.
Start the engine and with the drivers window down and the doors shut lean in through the window and hold in the SLS Lift and lower button on the dash. once the light starts flashing on the dash leave it alone and slowly the air bag should inflate.

If you have the chasis supported too high with the jack the sensors are telling the ECU that the lift is OK but it's not. Repeat for the other side.

This worked for me and I hope it works for you.

BradM

Thanks Fella's
Just the info i was after.
I'll go and play with my suspension now