Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: D2 LT230 Front Output Bearing Part No

  1. 7th February 2010, 05:54 PM #11
    d2dave's Avatar
    d2dave
    d2dave is offline ForumSage Subscriber
    Join Date
    May 2009
    Location
    Tatura, Vic
    Posts
    6,336
    Total Downloaded
    0
    Thomas,
    If possible try and get a 6207 TB or TMB. The TM should have a seal and be filled with grease. Leave the seal as oil can still get into the bearing but it acts like a filter and helps keep debris out.

    Dave.
    Reply With Quote Reply With Quote
  2. 8th February 2010, 06:56 PM #12
    TJS-70Y's Avatar
    TJS-70Y
    TJS-70Y is offline Master
    Join Date
    Aug 2006
    Location
    Coffs Harbour NSW
    Posts
    451
    Total Downloaded
    0
    There is no C3 prefix on the bearing I took out. I will take it to the bearing place in the next day or so and see what the outcome is.

    Thomas
    Reply With Quote Reply With Quote
  3. 10th February 2010, 11:47 AM #13
    TJS-70Y's Avatar
    TJS-70Y
    TJS-70Y is offline Master
    Join Date
    Aug 2006
    Location
    Coffs Harbour NSW
    Posts
    451
    Total Downloaded
    0
    I ended up getting a c3 prefix bearing and putting it in yesterday afternoon. It went straight in. I asked about the TM and TMB bearings but thy didn't have the right ones in stock. The guy also said that the output flange seal on the outside is more than enough protection. Also said the mixture of grease and oil would break down faster under higher temps.

    Thanks for all the help everyone.

    Thomas
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Overdrive | Drying time for silicone gasket »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!