Thread: Rijidij 130 rear wheel carrier

Hi Murray,
Does the new dual carrier bar fit the back of a 130 with the standard tub and still allow the tailgate to fold down all the way or will it stick out too far?

Regards,
Scott

Originally Posted by scottvdw

Hi Murray,
Does the new dual carrier bar fit the back of a 130 with the standard tub and still allow the tailgate to fold down all the way or will it stick out too far?

Regards,
Scott

G'day Scott,
Unfortunately the dual carrier, as with the single carrier, wont fit the 130 because of the overhang of the tub or tray. The single carrier I make for the 130 is a completely different design to the 110-90, so the same would have to be done with a 130 dual carrier.

Cheers, Murray

Hi Murray,
Great work !!
If you haven't already thought about it, paranoid people like myself would want a locking device for the Jerries.

Regards,
David

Originally Posted by DeeJay

Hi Murray,
Great work !!
If you haven't already thought about it, paranoid people like myself would want a locking device for the Jerries.

Regards,
David

Hi DeeJay,
There are extra holes at the top of the jerry holders through which you could use a cable and padlock. At this stage I haven't thought any further than that, but it wouldn't be too difficult to retrofit a hinged panel that goes right over the top of the fillers, preventing theft of either the jerry or the contents.

A similar idea to this, only over both cans.



Cheers, Murray

Murray
Have you considered a double Jerry carrier like on the RSV Perentie 110? The cargo door can be opened without moving the jerry carrier.

My rear cross member (Perentie) is a bit like your addition with lights mounted lower.

Originally Posted by rar110

Murray
Have you considered a double Jerry carrier like on the RSV Perentie 110? The cargo door can be opened without moving the jerry carrier.

My rear cross member (Perentie) is a bit like your addition with lights mounted lower.

I haven't considered it, but anything is possible.

One thing I have considered with the swing out jerry arm is a table that hooks onto the back of it in the open position.

Cheers, Murray

Well Murray , I want you to make a storage bin with lockable door to go at the bottom of the rear quarter panel .

Like these Terrafirma - Land Rover TF887

And a air vent for the pass side front panel to extract heat from under the bonnet ....my wish lists anyway

Between work and preparing for a trip things have been a bit crazy around here, but I managed to get the prototype rear bar finished.
We leave for Cape York this Friday, so the bar and carriers will get a good workout over the next four weeks........can't wait to hit the road.

Cheers, Murray