Page 6 of 25 FirstFirst ... 4567816 ... LastLast
Results 51 to 60 of 250

Thread: Defender Puma 2.2 - voice your issues

  1. #51
    Join Date
    May 2007
    Location
    Safety Bay
    Posts
    8,041
    Total Downloaded
    0
    ^ yep,drove my Tdi like I stole it,getting near 500,000k's without any oil burning,my TDCi was bouncing off the limiter an hour after I picked it up from the dealer,only issue is I've now noticed driveline slap,my axle flanges have both got play in them,a new pair from Paddocks for 25 pounds will be ordered tonight. Pat

  2. #52
    Join Date
    Jun 2013
    Location
    Sydney
    Posts
    1,380
    Total Downloaded
    0
    Mine gets a good push every now and then from two different angles when its been thoroughly warmed:
    - full throttle workout with revs relatively low (upshift 2000-2500rpm)
    - then let her spin right up in each gear to just over 4000rpm

    Just to blow the soot out.

  3. #53
    n plus one Guest
    Same, babying them doesn't seem to do them any favours for what I've seen.

    And you certainly won't by lugging 2,000rpm up hill in sixth once you've fitted an egt -- they go through the roof with this kind on driving style and the standard puma fuel is (apparently) more than capable of cooking the turbo....

  4. #54
    Join Date
    Aug 2013
    Location
    newcastle
    Posts
    411
    Total Downloaded
    0
    Quote Originally Posted by BilboBoggles View Post
    oops double post deleted
    Jesus, Im not even sure what Im on about there.

    Hmmm..

  5. #55
    Join Date
    Jan 2009
    Location
    Cairns
    Posts
    40
    Total Downloaded
    0

    Using water?

    I've just had a look with the intent to buy a 2012 model with 50000 on it. All seems in order however I noticed the power steering fluid was on minimum... Perhaps not a big deal...?? The coolant level was about a thumb width below the cold level though. I'm wondering if it was just leaking around the cap, did appear to be some fluid in the thread buts could it be more sinister?

  6. #56
    Join Date
    Dec 2006
    Location
    Hamilton, NZ
    Posts
    92
    Total Downloaded
    0
    I noticed that the power steering fluid was almost on the bottom of the dipstick on my 2012 model last week. I can't see where it has leaked out. But have bought some of the official stuff at $50 a litre so that I can keep an eye on it.

    Kerry

  7. #57
    Join Date
    May 2007
    Location
    Safety Bay
    Posts
    8,041
    Total Downloaded
    0
    Your coolant and PS fluid will go up and down depending on what the vehicle is doing at the time,don't overfill either or it'll spray out of the cap. Pat

  8. #58
    AndyG's Avatar
    AndyG is offline YarnMaster Silver Subscriber
    Join Date
    Jan 2014
    Location
    PNG
    Posts
    3,216
    Total Downloaded
    0
    Collected Defender in early Sept, 5000 km in two weeks including Birdsville & Strezleki Track, 5000 k service at independent with objective to find classic defects, result , Zero

    I got lucky or they got it right.

    Apart from some dust ingress of course, but those tracks were a fair test.
    By all means get a Defender. If you get a good one, you'll be happy. If you get a bad one, you'll become a philosopher.
    apologies to Socrates

    Clancy MY15 110 Defender

    Clancy's gone to Queensland Rovering, and we don't know where he are

  9. #59
    Damo89 Guest
    Quote Originally Posted by AndyG View Post
    Apart from some dust ingress of course, but those tracks were a fair test.
    Funny you mention this. I picked up my 110SW in August and have noticed a lot of sand and dust comes in, especially through the bottom of the rear doors. I looked on here for after market door seals but heard the new genuine LR ones were the way to go. Considering mine have these seals already, is there anything else I can do to combat the sand and dust coming in?

    Also - just hit 5000km's - should I be looking at some kind of service? LR told me not to worry until 20,000km.

  10. #60
    Join Date
    Feb 2009
    Posts
    286
    Total Downloaded
    0
    I am also interested in what are the classic defects to look for?

Page 6 of 25 FirstFirst ... 4567816 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!