Page 1 of 3 123 LastLast
Results 1 to 10 of 26

Thread: D2 2000 TD5 black smoke

  1. 21st January 2013, 04:41 PM #1
    DWN06 Guest

    D2 2000 TD5 black smoke

    Hi all my TD5 still blowing lots of black smoke under load have done the below to try and fix.
    • replaced wireing loom complete
    • replaced ECU, MAP, MAF improved get up and go of the engine
    • new exhaust system
    • removed EGR
    • replaced boost swtich (near AC compressor)
    • freed up waste gate
    • it still surges with cruise control on
    • fiitted provent 200
    bought nancom still not how to tell were it tell me how it's over fueling
    can anyone give me some more clues on how to stop the black soot asd it never happened until the oil in the wiring loom???
    Reply With Quote Reply With Quote
  2. 21st January 2013, 07:40 PM #2
    Disco Muppet's Avatar
    Disco Muppet
    Disco Muppet is offline Moderator Gold Subscriber
    Join Date
    Apr 2012
    Location
    Orange, NSW
    Posts
    7,965
    Total Downloaded
    0
    Check the turbo hoses for de-lamination, don't be fooled if they look okay on the outside
    It's either getting too much fuel or not enough air
    The Phantom - Oslo Blue 2001 Td5 SE.
    Half dead but will live again!

    Nina - Chawton White 2003 Td5 S
    Slowly being improved

    Quote Originally Posted by Judo View Post
    You worry me sometimes Muppet!!

    Reply With Quote Reply With Quote
  3. 21st January 2013, 10:08 PM #3
    bblaze
    bblaze is offline Wizard Subscriber
    Join Date
    Apr 2007
    Location
    NW Tassie
    Posts
    1,884
    Total Downloaded
    0
    first thing I would check is blocked air filter element, then as above, condition of all intake system
    cheers
    blaze
    Reply With Quote Reply With Quote
  4. 22nd January 2013, 06:59 AM #4
    DWN06 Guest
    Good Morning

    have used my nancom this morning found these codes not sure what they should be

    Config tune: STTDP007
    Fuel Tune: STHDE 017

    where can i find what setting should be?
    Reply With Quote Reply With Quote
  5. 22nd January 2013, 08:01 AM #5
    Tombie Guest
    They are just your fuel map identifiers...

    You need to either:

    Replace your hoses with Silicone ones

    Or Your waste gate is jammed open / sticking


    You should replace the hoses anyway Bet it fixes the problem
    Reply With Quote Reply With Quote
  6. 22nd January 2013, 08:15 AM #6
    OffTrack's Avatar
    OffTrack
    OffTrack is offline YarnMaster
    Join Date
    Feb 2011
    Location
    Brunswick, Victoria
    Posts
    3,778
    Total Downloaded
    0
    To add my voice to the chorus:

    Replace your turbo hoses and check the air filter.
    Reply With Quote Reply With Quote
  7. 22nd January 2013, 04:08 PM #7
    DWN06 Guest
    Hi all

    have replaced hoses today the old one looked ok, se how we go. air filter id only 5K old.
    r
    guy
    Reply With Quote Reply With Quote
  8. 22nd January 2013, 04:12 PM #8
    Mellow Yellow's Avatar
    Mellow Yellow
    Mellow Yellow is offline Master Gold Subscriber
    Join Date
    Jun 2009
    Location
    North Avoca
    Posts
    194
    Total Downloaded
    0
    Have you checked with your Nanocom that your MAF is providing a reading?
    Mellow Yellow

    No matter what the problem - there's a solution. You've just got to find it.

    2013 Discovery 4 TDV6 3.0
    2015 Defender 90 - The TARDIS (Gone)
    2003 Defender 110 - The Yellow Peril (Gone but remembered fondly)
    2001 Discovery II TD5 (Gone)
    1986 County V8 (Gone)
    Reply With Quote Reply With Quote
  9. 24th January 2013, 07:59 PM #9
    DWN06 Guest
    well thing can only get better got letter today from RTA, someone reported my car blowing to much black smoke, have to take it in for them to check now.
    Reply With Quote Reply With Quote
  10. 24th January 2013, 09:15 PM #10
    mattg Guest

    D2 2000 TD5 black smoke

    Are you using oil?

    Compression test through injector wholes and while your at I'd replace injector washers and o rings

    How many km on the clock.

    Cheers Matt
    Reply With Quote Reply With Quote
Page 1 of 3 123 LastLast
« td5 timing chain pressurising | TD5 EGR Blanking Kit Alloy vs Steel? »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!